Abstract:Incineration is widely applied in municipal solid waste treatment and energy recovery, especially in China. The efficiency of energy recovery does not only depend on the design and construction of equipment, but it is also highly affected by the operation. Primary air temperature is a key parameter for incinerator operation, but there is still limited information about how primary air temperature affects MSW incineration. Fluid dynamic incinerator code (FLIC) and Fluent coupled model was used to study the influence of different primary air temperatures on MSW incineration in a moving grate incinerator with five zones of primary air feeding. Four different conditions were investigated and compared, namely, control case (20 degrees C for five grate zones), case 180 (180 degrees C for five grate zones), case I (190 degrees C for two front zones, and 180 degrees C for three behind zones) and case II (190 degrees C for two front zones, 170 degrees C for two middle zones, 160 degrees C for the last zone). The result demonstrated, as the air preheating temperature increased, so did the rate of moisture evaporation and volatile release, the latter of which could potentially lead to higher local maximum temperature in the furnace. It was possible, by using the different primary air temperature setup, to maintain a relatively high rate of moisture evaporation and total mass loss, while having a lower rate of volatile release. Ultimately, the multi-temperature primary air setup maintained a high time-average rate evaporation of moisture at 0.04230518 kg/m(2) s, and lowers the time-averaged rate of volatile release to 0.0396193 kg/m(2) s, thus, maintained the local maximum furnace temperature at 1685 degrees C. This concept can potentially be utilized in MSW incinerators to effectively evaporate moisture from MSW while keeping the local maximum temperature in the furnace to a reasonable temperature.

Three-dimensional Monte-Carlo Modeling of Radiative Transfer in a Municipal Solid Waste Incinerator

Integrated modeling of bed temperature for a circulating fluidized bed incinerator

Modeling of an MSW Incinerator

Three-Dimensional Numerical Modeling and Analysis for the Municipal Solid-Waste Incineration of the Grate Furnace for Particulate-Matter Generation

Numerical simulation and intelligent prediction of a 500 t/d municipal solid waste incinerator

CFD simulation of MSW combustion and SNCR in a commercial incinerator

Numerical Optimization Study of Combustion and Heat Transfer Characteristics in Municipal Solid Waste Incinerators

Heat Transfer in a Municipal Solid Waste Incinerator

Comprehensive Assessment and Optimization of a Middle-Arch Dual-Channel Municipal Solid Waste Incinerator Using Numerical Simulation Methods

A two-fluid model simulation of an industrial moving grate waste incinerator

Mathematical modeling of combustion in a grate-fired boiler burning straw and effect of operating conditions under air- and oxygen-enriched atmospheres

Numerical Simulation of Combustion and Characteristics of Fly Ash and Slag in a “V-type” Waste Incinerator

Zone Modeling of Radiative Heat Transfer in Industrial Furnaces Using Adjusted Monte-Carlo Integral Method for Direct Exchange Area Calculation

Study on Drying and Combustion Process in Grate-Cfb Incinerator

A Model Featuring the Formation of Pollutants in a Grate-CFB(Circulating Fluidized Bed) Compound Solid Waste Incinerator

Influence of Multi-Temperature Primary Air on the Characteristics of MSW Combustion in a Moving Grate Incinerator

Computational Fluid Dynamics Simulation of Combustion and Selective Non-Catalytic Reduction in a 750 T/d Waste Incinerator

Model for Waste Combustion in a Grate-Cfb

Numerical Simulation of Asphalt Pavement Temperature Distribution in Long Tunnel Fires

Mechanism of Working Fluid Circulation in the Multisource Organic Solid Waste Incinerator

Experimental Study for Radiative Heat Transfer of High Moisture Flue Gas