Abstract:Brownian diffusion, inter-particle interactions, shear-induced diffusion and hydrodynamic lift forces all contribute to restricting the formation of concentration polarization (CP) during cross-flow membrane filtration of particles. In this study, a unified CP model was developed for the quantification of the CP formation of colloidal particles. The basic methods adopted in previous models such as mass balance equation accounting for particle diffusion and convection, disintegration of the solid pressure and osmotic pressure and derivation of particle drift velocity are kept. In the new model, the hydrodynamic lift force is taken into account in the force balance equations and shear-induced diffusion is included in the particle transport process. The simulation results show that the inter-particle interactions and the hydrodynamic lift force are predominant for relatively small and large particles, respectively. More specifically, while the inter-particle interactions are important for relatively small (e.g. 2a=10nm) particles, the hydrodynamic lift force dominates for relatively large particles (e.g. 2a=1μm). Neither inter-particle interactions nor hydrodynamic lift forces play a significant role in CP formation of sub-micro particles (e.g. 2a=100nm), for which the solid fraction buildup within the CP formation is most severe. For filtration of relatively large particles under a fixed hydrodynamic condition, it appears that there is a critical flux, over which the particle deposition rate will increase dramatically. Similarly, at a fixed filtration flux, there exists a critical shear stress induced by the cross-flow, over which the membrane fouling rate will decrease sharply. Use of a higher shear intensity can effectively alleviate membrane fouling caused by particles of all size ranges.

A Model for a Compressible Particle Layer of Charged Particles

Modulation to Compressible Homogenous Turbulence by Heavy Point Particles. I. Effect of Particles' Density

Development and Validation of Filtered Drag Models for Fluidization of Low-Density Geldart A Particles

Relationship Between Particle Charge and Electrostatic Enhancement of Filter Performance

Effect of electrostatic charge on aerosol filtration by nuclepore filters

Designing Multi-Layer electret filters via numerical simulation

Research note: Pressure drop and penetration for pre-charged and neutral particles on fibrous and membrane filters

Modeling and prediction of loading characteristics of electret filter media for PM2.5

Effects of the collision model in interface-resolved simulations of particle-laden turbulent channel flows

Mechanisms of performance degradation and efficiency improvement of electret filters during neutral particle loading

A unified model for quantification of concentration polarization (CP) of particles during cross-flow membrane filtration

Enhancing the capturing characteristics of charged droplets on submicron particles: An experimental and numerical investigation

Numerical Investigation into the Non-uniform Soot Layer Distribution in a Diesel Particle Filter

Progress of the Control Technology of the PM 10 from Combustion Sources

Effect of the Electrostatics on the Fibrous Filter Filtrating Fly Ash

Numerical Simulation of Fine Particles Trapping Process Using a Wall-Flow Honeycomb Filter

Modeling of the Initial Deposition of Individual Particles During the Cross-Flow Membrane Filtration

The effects of particle charge on the performance of a filtering facepiece

The pressure drop of fibrous surface filters for gas Filtration: Modeling and experimental studies

Experimental Investigation on Deposition Configuration of Soot Layer in Diesel Particle Filter

A Statistical Model of Pressure Drop Increase with Deposition in Granular Filters