Progress of the Control Technology of the PM 10 from Combustion Sources

YAO Qiang,LI Shuiqing,SONG Qiang,HUANG Bin,XU Haiwei,LIU Guanqing
2010-01-01
Abstract:0BAbstract: The particulate and combustion engineering (PACE) group is a vigorous research team dedicated to the study and application of the control technology of the PM10 from combustion sources in the Tsinghua University in china. Most of our recent work has been on the filtration and clean of the charged particles. First, different filters were tested systematically in various filtration conditions, including charging the particles as pretreatment. It was found that charged particles slowed the clogging and made increase rate of pressure drop larger than in neutralized cases and the penetration varied a lot. Second, direct observation of particle deposit on a single fiber was conducted to investigate the mechanism of the described phenomena. It was found that when the particles were charged, straight chains or chains with branches on which particles were evenly distributed were formed. Moreover, the discrete element method (DEM) based on JKR theory of adhesive elastic contacts, was used for three-dimensional simulations. A dimensionless adhesion parameter is defined and shown to have a dominant effect on the predicted particle deposition rate. Third, a continuous filtration bench was set up according to VDI 3926 to investigate the differences of cake detachment stresses between charged particle filtration and common filtration. The cake cleaning is carried out under a slowly increased reverse flow, when the overall pressure drop and cake detached is recorded. Primary results show that with the same filter, charged particle cake is harder to remove.
What problem does this paper attempt to address?