Abstract:Low-voltage clock generation and modulation are important to have dynamic voltage scaling for low-power SoC design or to enable the chip to be directly powered by energy harvesters for IoT applications. Even though the supply voltage of an integer-N PLL has reached 0.4V [1], designing a robust fractional-N PLL under 0.5V is still challenging as both a high-performance phase detector (PD) and an effective ΔΣ quantization noise (Q-noise) reduction method are required at low voltage. As shown at the top of Fig. 14.7.1, the time resolution of a DTC is severely degraded as supply voltage decreases, and the use of a circuit’s intrinsic time delay as reference base is not stable over PVT variations. Even though voltage-domain compensation methods [2, 3] achieve lower noise and better linearity, they must first convert the phase error from the time domain to the voltage domain, which causes nonlinearity issues and consumes significant voltage headroom for ultra-low-voltage (ULV) operations. To the best of authors’ knowledge, the lowest supply voltage for a published fractional-N PLL is 0.5V, but it uses an on-chip voltage booster to supply a higher internal voltage for the TDC [4] or must use large decoupling capacitors for the TDC in product-level designs. Given the fact that the use of a large decoupling capacitor with supply regulation is required in practice to achieve robust in-band noise performance, a time-interleaving flip-flop phase detector (TI-FFPD) has been proposed as an efficient PD structure, which achieves high linearity and low reference spur for a ring-VCO-based integer-N PLL [5]. By leveraging the advantage of the TI-FFPD, this paper presents a sub-0.5V bias-current-free fractional-N PLL with a calibration-free voltage-mode phase interpolator (VPI) for Q-noise cancellation, achieving sub-600fs rms jitter and <-57dBc worse-case fractional spur at 2.4GHz output.

A Linear Voltage Regulator for PLL in SOC Application

A Novel Fully On-Chip CMOS Low-Dropout Linear Regulator with Ultra Low Noise

A Low-dropout Regulator with Low Quiescent Current and High Stability

Low Dropout Linear Regulator with No Off-Chip Capacitor and Low Power Consumption

A 0.8 V Low Power Low Phase-Noise Pll

A 100 mA Low Voltage Linear Regulators for Systems on Chip Applications Using 0.18 μm CMOS Technology

A 0.6V 50-to-145mhz PVT Tolerant Digital PLL with DCO-dedicated ΔΣ LDO and Temperature Compensation Circuits in 65nm CMOS

A Low-Power RF CMOS Charge Pump PLL

A Low Noise High PSR LDO Based on N-type Flipped Voltage Follower

A Low Noise, Fast Set-Up Low-Dropout Regulator in 65nm Technology

A Low Noise High PSRR LDO for RF SOC Applications

14.7 A 0.45V 0.72mw 2.4ghz Bias-Current-Free Fractional-N Hybrid PLL Using a Voltage-Mode Phase Interpolator in 28nm CMOS

Design of reference voltage source integrated in LCoS chip

A Low Drop-out Voltage Regulator with Improved PSRR

A 0.0048mm2 0.43-to-1.0v 0.54-to-1.76ghz Bias-Current-Free PLL in 14nm FinFET CMOS

Wide operation range high-voltage linear regulator chip design

A 0.6V High-Swing Gate-Switching Charge Pump for PLL with Current Self-Matching Technique in 28nm CMOS

A 0.8-V, 2.55-Ghz, 2.62-Mw Charge-Pump PLL with High Spectrum Purity

A 1.2 V 70 mA low drop-out voltage regulator in 0.13 µm CMOS process

A Bias-Current-Free Fractional-N Hybrid PLL for Low-Voltage Clock Generation

Linear CMOS $LC$ -VCO Based on Triple-Coupled Inductors and Its Application to 40-GHz Phase-Locked Loop