Abstract:Low-voltage clock generation and modulation are important to have dynamic voltage scaling for low-power SoC design or to enable the chip to be directly powered by energy harvesters for IoT applications. Even though the supply voltage of an integer-N PLL has reached 0.4V [1], designing a robust fractional-N PLL under 0.5V is still challenging as both a high-performance phase detector (PD) and an effective ΔΣ quantization noise (Q-noise) reduction method are required at low voltage. As shown at the top of Fig. 14.7.1, the time resolution of a DTC is severely degraded as supply voltage decreases, and the use of a circuit’s intrinsic time delay as reference base is not stable over PVT variations. Even though voltage-domain compensation methods [2, 3] achieve lower noise and better linearity, they must first convert the phase error from the time domain to the voltage domain, which causes nonlinearity issues and consumes significant voltage headroom for ultra-low-voltage (ULV) operations. To the best of authors’ knowledge, the lowest supply voltage for a published fractional-N PLL is 0.5V, but it uses an on-chip voltage booster to supply a higher internal voltage for the TDC [4] or must use large decoupling capacitors for the TDC in product-level designs. Given the fact that the use of a large decoupling capacitor with supply regulation is required in practice to achieve robust in-band noise performance, a time-interleaving flip-flop phase detector (TI-FFPD) has been proposed as an efficient PD structure, which achieves high linearity and low reference spur for a ring-VCO-based integer-N PLL [5]. By leveraging the advantage of the TI-FFPD, this paper presents a sub-0.5V bias-current-free fractional-N PLL with a calibration-free voltage-mode phase interpolator (VPI) for Q-noise cancellation, achieving sub-600fs rms jitter and <-57dBc worse-case fractional spur at 2.4GHz output.

A 0.0048mm2 0.43-to-1.0v 0.54-to-1.76ghz Bias-Current-Free PLL in 14nm FinFET CMOS

A 0.8 V Low Power Low Phase-Noise Pll

A 40 Ghz 65 Nm Cmos Phase-Locked Loop with Optimized Shunt-Peaked Buffer

A Low Power Sub-GHz PLL with Optimized Class-C Voltage-controlled Oscillator

14.7 A 0.45V 0.72mw 2.4ghz Bias-Current-Free Fractional-N Hybrid PLL Using a Voltage-Mode Phase Interpolator in 28nm CMOS

A Low Power Sub-GHz PLL with Optimized LO Distribution Circuit

A Bias-Current-Free Fractional-N Hybrid PLL for Low-Voltage Clock Generation

A Low-Spur Current-Biasing-Free Fractional-N Hybrid PLL for Low-Voltage Clock Generation

A Low-Power RF CMOS Charge Pump PLL

A Low-Voltage Bias-Current-Free Pseudo-Differential Hybrid PLL Using a Time-Interleaving Flip-Flop Phase Detector

A Compact, Low-Power, and Low-Jitter Fractional-N Phase-Locked Loop with a Single-Ended Ring Voltage-Controlled Oscillator in a 12 Nm CMOS FinFET

An Ultra-Low-Voltage Bias-Current-Free Fractional- $N$ Hybrid PLL with Voltage-Mode Phase Detection and Interpolation

A Self-Biased PLL with Low Power and Compact Area

A 29.5 to 31.7 GHz PLL in 65 Nm CMOS Technology

A 1.75 mW 1.1 GHz semi-digital fractional-N PLL with TDC-less hybrid loop control

Design of Low-noise、Low-power Consumption CMOS CPPLL

A Fully Synthesizable All-Digital PLL With Interpolative Phase Coupled Oscillator, Current-Output DAC, and Fine-Resolution Digital Varactor Using Gated Edge Injection Technique

Semidigital PLL Design for Low-Cost Low-Power Clock Generation

A 0.8-V, 2.55-Ghz, 2.62-Mw Charge-Pump PLL with High Spectrum Purity

A 0.6/1.2-V 14.1-Mw 96.8Ghz-to-108.5ghz Transformer-Based Pll with Embedded Phase Shifter in 65-Nm Cmos

A Low Jitter PLL in a 90nm CMOS Digital Process