Abstract:Low-voltage clock generation and modulation are important to have dynamic voltage scaling for low-power SoC design or to enable the chip to be directly powered by energy harvesters for IoT applications. Even though the supply voltage of an integer-N PLL has reached 0.4V [1], designing a robust fractional-N PLL under 0.5V is still challenging as both a high-performance phase detector (PD) and an effective ΔΣ quantization noise (Q-noise) reduction method are required at low voltage. As shown at the top of Fig. 14.7.1, the time resolution of a DTC is severely degraded as supply voltage decreases, and the use of a circuit’s intrinsic time delay as reference base is not stable over PVT variations. Even though voltage-domain compensation methods [2, 3] achieve lower noise and better linearity, they must first convert the phase error from the time domain to the voltage domain, which causes nonlinearity issues and consumes significant voltage headroom for ultra-low-voltage (ULV) operations. To the best of authors’ knowledge, the lowest supply voltage for a published fractional-N PLL is 0.5V, but it uses an on-chip voltage booster to supply a higher internal voltage for the TDC [4] or must use large decoupling capacitors for the TDC in product-level designs. Given the fact that the use of a large decoupling capacitor with supply regulation is required in practice to achieve robust in-band noise performance, a time-interleaving flip-flop phase detector (TI-FFPD) has been proposed as an efficient PD structure, which achieves high linearity and low reference spur for a ring-VCO-based integer-N PLL [5]. By leveraging the advantage of the TI-FFPD, this paper presents a sub-0.5V bias-current-free fractional-N PLL with a calibration-free voltage-mode phase interpolator (VPI) for Q-noise cancellation, achieving sub-600fs rms jitter and <-57dBc worse-case fractional spur at 2.4GHz output.

A Low-Voltage Bias-Current-Free Pseudo-Differential Hybrid PLL Using a Time-Interleaving Flip-Flop Phase Detector

A 0.8 V Low Power Low Phase-Noise Pll

A Bias-Current-Free Fractional-N Hybrid PLL for Low-Voltage Clock Generation

An Ultra-Low-Voltage Bias-Current-Free Fractional- $N$ Hybrid PLL with Voltage-Mode Phase Detection and Interpolation

14.7 A 0.45V 0.72mw 2.4ghz Bias-Current-Free Fractional-N Hybrid PLL Using a Voltage-Mode Phase Interpolator in 28nm CMOS

A Low-Spur Current-Biasing-Free Fractional-N Hybrid PLL for Low-Voltage Clock Generation

A High Swing Charge Pump with Current Mismatch Reduction for PLL Applications

A Low Power Sub-GHz PLL with Optimized Class-C Voltage-controlled Oscillator

A New Type of Charge-Pump Circuit for Low-Voltage High-Speed PLL Application

A 0.0048mm2 0.43-to-1.0v 0.54-to-1.76ghz Bias-Current-Free PLL in 14nm FinFET CMOS

A Low-Power RF CMOS Charge Pump PLL

A Low-Cost, Leakage-Insensitive Semi-Digital PLL with Linear Phase Detection and FIR-embedded Digital Frequency Acquisition

Semidigital PLL Design for Low-Cost Low-Power Clock Generation

A Hybrid Frequency/phase-Locked Loop for Versatile Clock Generation with Wide Reference Frequency Range

A Dividerless Pll with Low Power and Low Reference Spur by Aperture-Phase Detector and Phase-To-Analog Converter

Analysis and Design of a Sub-Sampling PLL of Low Phase Noise and Low Reference Spur

A 3.3-4.5GHz Fractional-N Sampling PLL with A Merged Constant Slope DTC and Sampling PD in 40nm CMOS

A 2.6ghz ΔΣ Fractional-N Bang-Bang PLL with FIR-Embedded Injection-Locking Phase-Domain Low-Pass Filter

15.1 A 0.0066mm2 780μw Fully Synthesizable PLL with a Current-Output DAC and an Interpolative Phase-Coupled Oscillator Using Edge-Injection Technique

A 0.022mm2 970µw Dual-Loop Injection-Locked PLL with −243db FOM Using Synthesizable All-Digital PVT Calibration Circuits

An Ultra Low Power Integer-N PLL with a High-Gain Sampling Phase Detector for IOT Applications in 65 nm CMOS