Abstract:This paper presents advancements in the performance of digital phase-locked loop (DPLL)s, with a special focus on addressing the issue of required gain calibration in the time-to-digital converter (TDC) within phase-domain DPLL structures. Phase-domain DPLLs are preferred for their simplicity in implementation and for eliminating the delta–sigma modulator (DSM) noise inherent in conventional fractional-N designs. However, this advantage is countered by the critical need to calibrate the gain of the TDC. The previously proposed dual-interpolated TDC(DI-TDC) was proposed as a solution to this problem, but strong spurs were still generated due to the TDC resolution, which easily became non-uniform due to PVT variation, degrading performance. To overcome these problems, this work proposes a DPLL with a new calibration system that ensures consistent TDC resolution matching the period of the digitally controlled oscillator (DCO) and operating in both the foreground and background, thereby maintaining consistent performance despite PVT variations. This study proposes a DPLL using a calibrated dual-interpolated TDC that effectively compensates for PVT variations and improves the stability and performance of the DPLL. The PLL was fabricated in a 28-nm CMOS process with an active area of only 0.019 mm2, achieving an integrated phase noise (IPN) performance of −17.5 dBc, integrated from 10 kHz to 10 MHz at a PLL output of 570 MHz and −20.5 dBc at 1.1 GHz. This PLL operates within an output frequency range of 475 MHz to 1.1 GHz. Under typical operating conditions, it consumes only 930 μW with a 1.0 V supply.

A Low-Cost, Leakage-Insensitive Semi-Digital PLL with Linear Phase Detection and FIR-embedded Digital Frequency Acquisition

A 0.8 V Low Power Low Phase-Noise Pll

A Low Power Sub-GHz PLL with Optimized Class-C Voltage-controlled Oscillator

A Hybrid Frequency/phase-Locked Loop for Versatile Clock Generation with Wide Reference Frequency Range

Semidigital PLL Design for Low-Cost Low-Power Clock Generation

A 1.75 mW 1.1 GHz semi-digital fractional-N PLL with TDC-less hybrid loop control

A Low-Power Calibration-Free Fractional-N Digital Pll with High Linear Phase Interpolator

A Low-Voltage Bias-Current-Free Pseudo-Differential Hybrid PLL Using a Time-Interleaving Flip-Flop Phase Detector

A Calibration-Free 800 MHz Fractional-N Digital PLL With Embedded TDC

A Low-Power and Small Chip-Area Fractional-N Digital PLL with Combination of DPI and TDC

A Low-Power RF CMOS Charge Pump PLL

An 8-14Ghz 180Fs-Rms DTC-Less Fractional ADPLL with ADC-Based Direct Phase Digitization in 40nm CMOS

A Bias-Current-Free Fractional-N Hybrid PLL for Low-Voltage Clock Generation

Enhanced FIR-embedded Noise Reduction Method with Hybrid Phase Detection for Semidigital Fractional-N Phase-Locked Loops

A 0.001-Mm$$^{2}$$ 112.32-$$\Upmu $$W All-Digital PLL with Dual-Tuned DCO and Dual-Tuned Control Algorithm

A Fully Synthesizable All-Digital PLL With Interpolative Phase Coupled Oscillator, Current-Output DAC, and Fine-Resolution Digital Varactor Using Gated Edge Injection Technique

An Ultra-Low-Voltage Bias-Current-Free Fractional- $N$ Hybrid PLL with Voltage-Mode Phase Detection and Interpolation

15.1 A 0.0066mm2 780μw Fully Synthesizable PLL with a Current-Output DAC and an Interpolative Phase-Coupled Oscillator Using Edge-Injection Technique

A Fully Synthesizable Fractional-N Digital Phase-Locked Loop with a Calibrated Dual-Referenced Interpolating Time-to-Digital Converter to Compensate for Process–Voltage–Temperature Variations

A 265-$\Mu$ W Fractional-${N}$ Digital PLL with Seamless Automatic Switching Sub-Sampling/Sampling Feedback Path and Duty-Cycled Frequency-Locked Loop in 65-Nm CMOS

A Low-Spur Current-Biasing-Free Fractional-N Hybrid PLL for Low-Voltage Clock Generation