Abstract:Low-voltage clock generation and modulation are important to have dynamic voltage scaling for low-power SoC design or to enable the chip to be directly powered by energy harvesters for IoT applications. Even though the supply voltage of an integer-N PLL has reached 0.4V [1], designing a robust fractional-N PLL under 0.5V is still challenging as both a high-performance phase detector (PD) and an effective ΔΣ quantization noise (Q-noise) reduction method are required at low voltage. As shown at the top of Fig. 14.7.1, the time resolution of a DTC is severely degraded as supply voltage decreases, and the use of a circuit’s intrinsic time delay as reference base is not stable over PVT variations. Even though voltage-domain compensation methods [2, 3] achieve lower noise and better linearity, they must first convert the phase error from the time domain to the voltage domain, which causes nonlinearity issues and consumes significant voltage headroom for ultra-low-voltage (ULV) operations. To the best of authors’ knowledge, the lowest supply voltage for a published fractional-N PLL is 0.5V, but it uses an on-chip voltage booster to supply a higher internal voltage for the TDC [4] or must use large decoupling capacitors for the TDC in product-level designs. Given the fact that the use of a large decoupling capacitor with supply regulation is required in practice to achieve robust in-band noise performance, a time-interleaving flip-flop phase detector (TI-FFPD) has been proposed as an efficient PD structure, which achieves high linearity and low reference spur for a ring-VCO-based integer-N PLL [5]. By leveraging the advantage of the TI-FFPD, this paper presents a sub-0.5V bias-current-free fractional-N PLL with a calibration-free voltage-mode phase interpolator (VPI) for Q-noise cancellation, achieving sub-600fs rms jitter and <-57dBc worse-case fractional spur at 2.4GHz output.

A 2.6ghz ΔΣ Fractional-N Bang-Bang PLL with FIR-Embedded Injection-Locking Phase-Domain Low-Pass Filter

A DTC-Free Fractional-N BBPLL with FIR-Embedded Injection-Locked-Oscillator-Based Phase-Domain Lowpass Filter

A Fractional-N PLL for Multiband (0.8–6 GHz) Communications Using Binary-Weighted D/A Differentiator and Offset-Frequency Δ-Σ Modulator

A Noise and Spur Reduction Technique for ΔΣ Fractional-N Bang-Bang PLLs with Embedded Phase Domain Filtering.

A Compact 0.8–6ghz Fractional-N PLL with Binary-Weighted D/A Differentiator and Offset-Frequency Δ−Σ Modulator for Noise and Spurs Cancellation

A fractional-NBB-DPLL with auto-tuned DTC and FIR filter for noise and spur reduction

A ΔΣ DPLL with 1b TDC, 4b DTC and 8-tap FIR filter for low-voltage clock generation/modulation systems

An 11.1-to-14.9ghz Digital-Integral Hybrid-Proportional Fractional-N PLL with an LC DTC Achieving 0.52μs Locking Time and 41.3f5 Jitter

Design and Analysis of DTC-Free ΔΣ Bang-Bang Phase-Locked Loops.

A 5.4ghz ΔΣ Bang-Bang PLL with 19db In-Band Noise Reduction by Using a Nested PLL Filter

Optimized System Design for Fully Integrated Fractional-N Pll

14.1 A 0.048mm2 3mW synthesizable fractional-N PLL with a soft injection-locking technique

An 8-14Ghz 180Fs-Rms DTC-Less Fractional ADPLL with ADC-Based Direct Phase Digitization in 40nm CMOS

A Bias-Current-Free Fractional-N Hybrid PLL for Low-Voltage Clock Generation

A Low-Power and Small Chip-Area Fractional-N Digital PLL with Combination of DPI and TDC

A 1.2ps-jitter fully-synthesizable fully-calibrated fractional-N injection-locked PLL using true arbitrary nonlinearity calibration technique

An Ultra-Low-Voltage Bias-Current-Free Fractional- $N$ Hybrid PLL with Voltage-Mode Phase Detection and Interpolation

A 56-GHz Fractional-N PLL With 110-fs Jitter

A Fully-Synthesizable Fractional-N Injection-Locked PLL for Digital Clocking with Triangle/Sawtooth Spread-Spectrum Modulation Capability in 5-Nm CMOS

A 1.75 mW 1.1 GHz semi-digital fractional-N PLL with TDC-less hybrid loop control

14.7 A 0.45V 0.72mw 2.4ghz Bias-Current-Free Fractional-N Hybrid PLL Using a Voltage-Mode Phase Interpolator in 28nm CMOS