Abstract:A novel design for a low dropout (LDO) voltage regulator is presented and dedicated to power many sections of a typical cellular handset. However, these baseband, RF, and audio sections have different requirements that influence which LDO is most appropriate. After discussion of the specific requirements, different LDOs are recommended. Also, some LDO design techniques are briefly discussed to demonstrate how an LDO may be optimized for a specific level of performance. Cellular phone designs require linear regulators with lowdropout, low-noise, high PSRR, low quiescent current (Iq), and low-cost. They need to deliver a stable output and use smallvalue output capacitors. Ideally, one device would have all these characteristics and one low-dropout linear regulator (LDO) could be used anywhere in the phone without worry. But in practice, the various cell phone blocks are best powered by LDOs with different performance characteristics. This paper provides a new design methodology to choosing the right LDO to power each cell phone and especially for the Voltage Phase-Locked loops (VPLLs) blocks. Fabricated in a 0.18 {\mu}m CMOS process, the measured results show the adopted topology achieves a better phase noise than the conventional saturation current source. and the spread of the current limitation (without matching) is 100mA, the VPLLs system demonstrates a phase noise of 782 nv/sqrtHz at 100-kHz, and 33 nv/sqrtHz at 1 MHz, while quiescent current 33 {\mu}A from a 2.6 V supply voltage.

Wide operation range high-voltage linear regulator chip design

High Stability LDO with Large Output Current

Highly Stable Low-Dropout Linear Regulator with Temperature Compensation

A 300 mA 0.18 μm CMOS low-dropout regulator with high power-supply rejection

Low Dropout Linear Regulator with No Off-Chip Capacitor and Low Power Consumption

Fully Integrated High-Voltage Level Shifts and Drivers for Buck Converters.

A Soft-Start Circuit for Low-Dropout (LDO) Regulator Using Temperature Compensation Technique

Design Of High Accuracy High Conversion Ratio Single-Stage Switching Power Converter For Modern Fpgas At 10mhz

A regulated charge pump with wide current driving capability for low-voltage applications

A Low-Power Voltage Reference Source for Lithium Battery Protection ICs

Design of wide power supply, high performance voltage regulator with BCD process

Design of Self-Referenced Wide Input Voltage Range LDO Using Enhanced Current Mirror Buffer and Improved Lead Compensation

A 100 mA Low Voltage Linear Regulators for Systems on Chip Applications Using 0.18 μm CMOS Technology

An Impedance Adapting Compensation Scheme for High Current NMOS LDO Design

A high-efficiency and wide-load current range LDO with dynamic loop gain control technique

High-conversion-ratio buck regulator for SoC in 0.13µm digital CMOS process

Research on High-Performance Low Dropout Linear Regulator

A Fully Integrated 1.8 V Low-Power LDO Regulator with Dynamic Transient Control for SoC Applications

A High-Performance LDO Regulator Enabling Low-Power SoC With Voltage Scaling Approaches

A Low-dropout Regulator with Low Quiescent Current and High Stability

A Linear Voltage Regulator for PLL in SOC Application