Abstract:The microstructure of peritectic alloys of important applications determines the final properties of them. The growth of peritectic β phase which greatly influences the structure of peritectic systems is divided into three different types: peritectic reaction at TP: L + α → β, then solid-state peritectic transformation α → β and direct precipitation L → β. In addition to transparent organic systems, peritectic transformation was always analyzed using interrupted directional solidification during which the sample is kept stationary after experiencing a distance of directional growth. Then, the growth of β phase through peritectic transformation is accompanied with the migration of the α/β interface towards α phase below TP. However, it is found in SnNi peritectic system (L + Ni3Sn2 → Ni3Sn4) that the migration rate of Ni3Sn2/Ni3Sn4 interface is much larger than that of peritectic transformation. Further examination shows that this interface migration can also be induced by the diffusion-controlled liquid migration initiating at the Ni3Sn2/Ni3Sn4 interface. Based on the model describing the liquid migration process, the migration of the Ni3Sn2/Ni3Sn4 interface through liquid migration is predicted, which matches well with the experimental measurement. This shows that the diffusion-controlled liquid migration is dominant during the growth of β phase. Thus, the application of interrupted directional solidification should be further examined.

Well-Aligned In Situ Composites In Directionally Solidified Fe-Ni Peritectic System

Producing Well Aligned in Situ Composites in Peritectic Systems by Directional Solidification

Peritectic Reaction and Its Influences on the Microstructures Evolution During Directional Solidification of Fe–Ni Alloys

Two-phase Separated Growth and Peritectic Reaction During Directional Solidification of Cu–Ge Peritectic Alloys

Directional Solidification and Microstructure Selection for Ti-Al Peritectic Alloy

Morphological Stability of Coupled Growth During Directional Solidification of Eutectic and Peritectic Alloys

Spacing selection of cellular peritectic coupled growth during directional solidification of Fe–Ni peritectic alloys

Non-equilibrium solidification of bulk undercooled Ni–P eutectic alloys

On Melt Concentration at the Solid/liquid Interface During Preparation of Directionally Solidified Sn–36 At.%ni Peritectic Alloy

Composition-dependent Phase Substitution in Directionally Solidified Sn-22at.%Ni Peritectic Alloy

Formation Mechanism of Band Structure and Phase Selection During Directional Solidification of Peritectic Alloys - Ii. Phase Selection

Phase and Microstructure Selection in Directionally Solidified Peritectic Alloys with Convection

Microstructure Evolution of Ti-Al Peritectic System During the Initiated Stage of Directional Solidification

Local Melting/solidification During Peritectic Solidification in a Steep Temperature Gradient: Analysis of a Directionally Solidified Al–25at%Ni

Convection Effects and Banding Structure Formation Mechanism During Directional Solidification of Peritectic Alloys Ii. Theoretical Analysis

Convection Effects and Banding Structure Formation Mechanism During Directional Solidification of Peritectic Alloys I. Experimental Result

Preparation of the Initial Solid–liquid Interface and Melt in Directional Solidification of Al–18at%Ni Peritectic Alloy

Liquid migration and peritectic transformation: Investigation on their contributions to growth of peritectic phase in interrupted directional solidification

On oscillatory microstructure during cellular growth of directionally solidified Sn–36at.%Ni peritectic alloy

Composite Growth in Highly Undercooled Ni70.2si29.8 Eutectic Alloy

Directional Solidification of Cu–20Sn Alloy at Low Speed: from Peritectic Coupled Growth to Banding