Abstract:Compared with traditional liquid and solid processing methods, semi-solid die casting process can apparently overcome shrinkage cavity and porosity defects in castings and high deformation resistance and high residual stress shortcomings in forging parts. Semi-solid die casting process with advantages such as high efficiency and low cost, will become the optimal process for high quality automobile parts. In this study, using the clamp as an example, the author introduced product structure optimization and die design for semi-solid die-casting process of aluminum alloy in a new product development.The Computer Aided Engineering technology was applied to the product structure optimization according to the stress analysis. The optimal mold structure, including cavity layout, gating system, overflow and vent systems, were confirmed based on the die design criteria for traditional die casting, combining with the characteristics of semi-solid forming and the simulation results. The semi-solid aluminum alloy clamp parts with excellent performances were finally developed successfully by means of product structure optimization, die design, parameters optimization of die casting process, and the mechanical properties test of products.The existing parts were optimized to make them more suitable for semi-solid die casting processing. In addition, a reasonable die design specially for semi solid processing was an important guarantee for a successful semi solid product applied in industry. Computer numerical simulation was applied in product structure design for semi-solid die casting, die design, die-casting process optimization and other aspects, to shorten the development cycle of new product, reduce cost and improve efficiency.

Discussion of Key Problems on Thixotropic Die-casting in Semi-solid Aluminum Alloys

Semi-solid processing of aluminum and magnesium alloys: Status, opportunity, and challenge in China

An Overview on the Process Development and the Formation of Non-Dendritic Microstructure in Semi-Solid Processing of Metallic Materials

Determination of casting parameters of thick wall die-casting of magnesium alloy and simulation of its processing

From semisolid metal processing to thixotropic 3D printing of metallic alloys

Semi-solid thixoforging of nondendritic AlSi7Mg alloy

Development of Semi-Solid Die Casting Process Technology for Aluminium Alloy Clamp

Experimental study on the thixoforming of high silicon-aluminum alloy and its application in automobile piston

On-line Preparation Technology of Semi-Solid Slurry of A356.2 Alloy

Study on Semi-Solid Magnesium Alloys Slurry Preparation and Continuous Roll-Casting Process

Actuality and future of semi-solid forming application

REVIEW OF NEW PROCESS TECHNOLOGIES IN THE ALUMINUM DIE-CASTING INDUSTRY

Study on Thxio-die-forging of 37%Al/Al_2O_3 Composite cup shell in Pseudo-semi-solid State

Study on the Reheating and Thixoforming of 7075 Aluminum Alloy Cast by Liquidus Semicontinuous Casting

Numerical Simulation and Experimental Study on Semi-solid Forming Process of 319s Aluminum Alloy Test Bar

Study on Semisolid Rheo-Diecasting Process, Microstructure and Mechanical Properties of Mg-6Al-1Ca-0.5Sb Alloy with High Solid Fraction

To Improve Robustness of Mechanical Properties of Semi-Solid Cast A356 Alloy Using Taguchi Design Method

Experimental Study On The Thixoforming Of Automobile Piston With High Silicon-Aluminum Alloy

Thixotropic Deformation Behavior, Rapid Spheroidization and Solid-Liquid Homogenization of Semi-Solid Al0.8Co0.5Cr1.5CuFeNi HEA with Multilevel Microstructure

Numerical Analysis of Semi-Solid Die-Casting Automobile Part Based on the Thermo-Visco-Plastic Constitutive Relation

Die Casting Semi-Solid ZL101 Alloy Prepared by Inclined Slope Cooling-Transferring Method and its Properties