Abstract:Publication date: 28 August 2023 Source: Solid State Phenomena Vol. 348 Author(s): Martin Hartlieb, Jean Claude Tawil, Stephane Bergeron, Per Jansson Structural high vacuum die casting has been growing significantly over the past decades. It is typically done with special (primary type) alloys, special melt treatment practices, high vacuum, a carefully engineered die casting process applying many best practices in our industry. Structural die castings are growing in size and complexity and die casting machines are getting bigger and bigger - and those castings are becoming a significant challenge with current technologies. It was now found that Rheocasting - a process of preparing a semi-solid slurry (with 30-45% solid fraction) that is injected slower and in a laminar way into the cavity, can take structural die casting to completely new heights, enable the casting of parts that would otherwise be impossible to cast and at the same time reduce or eliminate some of the current problems of structural die casting. With Rheocasting, lower purity (secondary) aluminum alloys can be used and excellent properties can be achieved as cast and heat treated (T5, T6/7). Rheocasting has had a breakthrough in the telecom and other industries, but it has now been optimized to become an essential tool in the toolbox of making structural castings. This paper shows the developments that lead to the successful series production of a large (about 4' long) hinge pillar for an Electric Vehicle (EV). It explains the challenges and how they were overcome, and some of the possibilities of the process regarding alloys, heat treatments and achievable properties. It also shows how Rheocasting can help die casters produce more complex (thin and thick walled) and very large castings with the highest integrity. It can replace structural low-pressure permanent mold (LPPM) castings and reduce wall thickness, improve tolerances and make them more economical. Rheocasting can enable die casters to enter this new market of structural castings including Gigacastings, produce parts previously thought impossible to cast (and on much smaller machines than thought), and expand the growing structural die casting market even faster and further.

REVIEW OF NEW PROCESS TECHNOLOGIES IN THE ALUMINUM DIE-CASTING INDUSTRY

Alloy development and process innovations for light metals casting

Development of Semi-Solid Die Casting Process Technology for Aluminium Alloy Clamp

Innovative Hybrid High-Pressure Die-Casting Process for Load-Bearing Body-In-White Structural Components

A powder-based approach to semisolid processing of metals for fabrication of die-castings and composites

Current State of Semi-Solid Net-Shape Die Casting

A Review on the Development of Processing Techniques for the Production and Casting of Al-Alloy and Metal Matrix Composite Material

Producing Structural High Integrity Castings with Minimum Carbon Footprint with the Comptech-Rheocasting Process

Production of Aluminum Alloy Sealing Part by Semi Solid Die Casting Method

Integration of Additive Fabrication with High-Pressure Die Casting for Quality Structural Castings of Aluminium Alloys; Optimising Energy Consumption

Porosity, cracks, and mechanical properties of additively manufactured tooling alloys: a review

Laser Additive Manufacturing of High-Strength Aluminum Alloys: Challenges and Strategies

Influence of High-Pressure Die Casting Process Parameters on the Compound Strength of Hybrid Components with Undercut Sheet Metal

Industrialization of Aluminum Alloy Uniform Solidification Controlled Rheological Die Casting

Venting Systems in Semi-Solid Processing of Aluminium

Discussion of Key Problems on Thixotropic Die-casting in Semi-solid Aluminum Alloys

Design of Non-Heat Treatable High Pressure Die Casting Al Alloys: A Review

Fabrication of aluminum metal matrix composite through continuous casting route: A review and future directions

Advances in Metal Casting Technology: A Review of State of the Art, Challenges and Trends—Part I: Changing Markets, Changing Products

Die casting process optimization using Taguchi methods