Abstract:Abstract The current options for solid‐state consolidation processing of powder‐based advanced aluminum alloys have been very limited and complicated, resulting in a segregation of the applications primarily to the aerospace segment. Throughout any consolidation sequence for aluminum powders, the oxide and/or hydroxide films on the typical powder surfaces can interfere with densification and interparticle bonding. In fact, the consolidation sequence for many low‐strength aluminum alloy powder metallurgy parts involves transient liquid‐phase sintering to massively disrupt the powder surfaces, producing improved bonding but introducing a coarsened resolidification microstructure. Although preventing aluminum oxide formation is nearly impossible during aluminum powder production, the gas atomization reaction synthesis (GARS) method—an advanced powder production technique—can modify the oxide coating and enable improved consolidation processing. This report compares the effects of the GARS process and other representative atomization processes on the surface structure and properties of aluminum powders and on their ability to sinter. The powders were characterized with transmission electron microscopy, scanning electron microscopy, Auger electron spectroscopy, quadrapole mass spectroscopy and with a new ultrasonic method for in situ sensing of the evolution of sintering. In general, a marked reduction in the surface film thickness and in the level of chemisorbed moisture and moisture‐borne impurities was observed in the GARS powders. This change in powder surface characteristics also was effective in promoting sintering processes in the GARS powders, as monitored by our new technique. An initial direct comparison of explosivity for the different types of aluminum powder revealed that the GARS powder also had a reduced hazard level. All of these findings indicate that the GARS approach to aluminum powder production may enable mass‐produced lightweight powder metallurgy parts from advanced aluminum alloys with simple consolidation processing techniques. Copyright © 2001 John Wiley & Sons, Ltd.

A powder-based approach to semisolid processing of metals for fabrication of die-castings and composites

New technique for preparing A356 alloy semisolid slurry and its rheo-diecast microstructure and properties

Rheo-Diecasting of Magnesium Alloys

Industrialization of Aluminum Alloy Uniform Solidification Controlled Rheological Die Casting

Powder-size driven facile microstructure control in powder-fusion metal additive manufacturing processes

New Processing Route for the Production of Functionally Graded 7075 Al/SiCp Composites via a Combination of Semisolid Stirring and Sequential Squeeze Casting

Inorganic/inorganic composites through emulsion templating

From semisolid metal processing to thixotropic 3D printing of metallic alloys

Semi-Solid Slurries for Rheocasting of Hypoeutectic Al-Si-X Alloys Produced by Self-Stirring in Serpentine Channels

REVIEW OF NEW PROCESS TECHNOLOGIES IN THE ALUMINUM DIE-CASTING INDUSTRY

Solid-state production of uniform metal powders for additive manufacturing by ultrasonic vibration machining

Efficient fabrication of semisolid nondendritic Al alloy slurry with high quality

Study on Semisolid Rheo-Diecasting Process, Microstructure and Mechanical Properties of Mg-6Al-1Ca-0.5Sb Alloy with High Solid Fraction

Determining the role of surfaces and interfaces in the powder metallurgy processing of aluminum alloy powders

An Overview on the Process Development and the Formation of Non-Dendritic Microstructure in Semi-Solid Processing of Metallic Materials

Tailoring metal powders by dry nanoparticle coating for powder bed fusion applications

Alloy development and process innovations for light metals casting

Metal casting using soluble pattern produced via additive manufacturing

The Effect of Initial Microstructure of A356 Alloys on the Mechanical Behavior in the Semisolid State

Magnetically-Assisted Slip Casting of Bioinspired Heterogeneous Composites