Abstract:Refractive index inhomogeneity is one of the important characteristics of optical coating material, which is one of the key factors to produce loss to the ultra-low residual reflection coatings except using the refractive index inhomogeneity to obtain gradient-index coating. In the normal structure of antireflection coatings for center wavelength at 532 nm, the physical thicknesses of layer H and layer L are 22.18 nm and 118.86 nm, respectively. The residual reflectance caused by refractive index inhomogeneity (the degree of inhomogeneous is between -0.2 and 0.2) is about 200 ppm, and the minimum reflectivity wavelength is between 528.2 nm and 535.2 nm. A new numerical method adding the refractive index inhomogeneity to the spectra calculation was proposed to design the laser antireflection coatings, which can achieve the design of antireflection coatings with ppm residual reflection by adjusting physical thickness of the couple layers. When the degree of refractive index inhomogeneity of the layer H and layer L is -0.08 and 0.05 respectively, the residual reflectance increase from zero to 0.0769% at 532 nm. According to the above accuracy numerical method, if layer H physical thickness increases by 1.30 nm and layer L decrease by 4.50 nm, residual reflectance of thin film will achieve to 2.06 ppm. When the degree of refractive index inhomogeneity of the layer H and layer L is 0.08 and -0.05 respectively, the residual reflectance increase from zero to 0.0784% at 532 nm. The residual reflectance of designed thin film can be reduced to 0.8 ppm by decreasing the layer H of 1.55 nm while increasing the layer L of 4.94 nm.

Optical Coatings Optimization of Semiconductor Laser

Antireflective Coatings Used for High-Power Co2-Laser

Design of Ultrabroadband Double-Chirped Mirror Pairs for Ultrafast Lasers

A-LOC GaAlAs/GaAs laser and its characteristics

Optimization of the cavity facet coating in high power GaN-based semiconductor laser diodes

Influence of interface layer on antireflection coating for laser optics

Multi-objective Numerical Simulation of Geometrical Characteristics of Laser Cladding of Cobalt-Based Alloy Based on Response Surface Methodology

Fabrication And Optical Properties Of Sol-Gel Derived Interference Coating For High Power Laser Applications

Antireflective laser coating with improved mechanical property and organic-contaminant resistance for high-power laser application

Design and fabrication of multilayer antireflection coating for optoelectronic devices by plasma enhanced chemical vapor deposition

Optimization of 1.3 Μm InAs/GaAs Quantum Dot Lasers Epitaxially Grown on Silicon: Taking the Optical Loss of Metamorphic Epilayers into Account

Accuracy Design of Ultra-Low Residual Reflection Coatings for Laser Optics

Improvement of cavity films and catastrophic optical damage on 980 nm semiconductor laser

Aging ef fect of optical properties on low loss antireflection coatings for laser optics

Optimization of the number of quantum wells in the active region for 2μm laser diode

Analysis and Fabrication of Antireflection Coating with Ultralow Residual Reflectance for Single Wavelength

LOW LOSS ANTIREFLECTION COATINGS FOR DF CHEMICAL LASER WINDOWS

Optimum End Reflectivity in External Semiconductor Lasers

Optimal Design of Quadruple-Layer Antireflection Coating Structure for Conversion Efficiency Enhancement in Crystalline Silicon Solar Cells

Optimization of 1300 Nm Quantum Well Laser on GaAs Substrates

Optimization of vertical coupling induced by 45° micro-mirrors in double-layer polymer optical waveguides with CO_2 laser smoothing