Research on Shear Deformation Localization in High-Strength Steel During Orthogonal Cutting

DUAN Chun-zheng,WANG Min-jie,PANG Jun-zhong,LI Guo-he
DOI: https://doi.org/10.3321/j.issn:1000-8608.2006.03.009
2006-01-01
Abstract:The critical cutting conditions of shear deformation localization,distributing laws and microstructures of adiabatic shear band in the serrated chips of high-strength steel 30CrNi3MoV are investigated by orthogonal cutting.The results show that the ribbon chips shift to the serrated chips at a certain critical cutting speed because of the occurrence of shear deformation localization in chip shear zones,which is in agreement with the theoretical prediction of the critical cutting speed,and that the shear band width and spacing gradually decrease with the increasing of the cutting speed.Two types of shear bands,i.e.deformed shear bands and white shear bands,are observed in the serrated chips.TEM observations reveal the equiaxed grains in the center of the white shear bands,and the microstructures in shear bands undergo a series of complicated evolution processes.
What problem does this paper attempt to address?