Abstract:A novel contactless conductivity detector with two electrodes integrated along the sidewalls of the ending separation channel of silicon-based electrophoresis microchip was presented in this paper,and factors influencing the response sensitivity of conductivity detection were discussed.Parameters of the detector were determined by MEMS analysis software and the equivalent circuit simulation,including electrode length of 550 μm,width of 15 μm,distance of 80 μm,thickness of insulation layer of 1 μm and conductivity detection frequency of 300 kHz.Silicon on insulator(SOI) was used in the fabrication process as the substrate to fabricate cross section micro channel and integrate conductivity detection electrodes.The technology of deep etching and isolation was used to isolate the detection electrodes from the micro channel,and the technology of ion diffusion was employed to fabricate tridimensional electrodes along the sidewalls of the ending separation channel,so that silicon-based electrophoresis microchip with integration of contactless conductivity detection electrodes was obtained.Under the excitation of sine wave with Vpp of 10 V and the operation frequency of 300 kHz,concentration gradient experiment for Na+ inorganic cation and electrophoresis separation detection for Na+ and Li+ hybrid inorganic cations were conducted.The results show that within the concentration range of Na+ from 1×10-9 mol/L to 1×10-4 mol/L,the conductivity response signal increases with the increase of Na+ concentration and the detection limit reaches 1×10-9 mol/L.The resolution of electrophoresis separation for Na+ and Li+ hybrid inorganic cations reaches 2.0,indicating that baseline separation is achieved.

Study of Capillary Electrophoresis Chip with Conductivity Detection

Design of movable contactless conductivity detector for microchip capillary electrophoresis

Contactless Conductivity Detector for Capillary Electrophoresis Chip

Contactless Conductivity Detector Integrated in Silicon-Based Electrophoresis Microchip

Detection of Inorganic Ions on a Capillary Electrophoresis Microchip Using a Conductivity Technique

A high-performance polycarbonate electrophoresis microchip with integrated three-electrode system for end-channel amperometric detection.

[Theoretical Study of Contactless Conductivity Detector for Electrophoresis Chip].

A Thin Cover Glass Chip for Contactless Conductivity Detection in Microchip Capillary Electrophoresis.

A Plug-in Electrophoresis Microchip with PCB Electrodes for Contactless Conductivity Detection

Movable Contact Less-Conductivity Detector for Microchip Capillary Electrophoresis

Integrated Universal Conductivity Detection For Chip Electrophoresis

A Glass/PDMS Hybrid Microfluidic Chip Embedded with Integrated Electrodes for Contactless Conductivity Detection

A Polydimethylsiloxane Electrophoresis Microchip with a Thickness Controllable Insulating Layer for Capacitatively Coupled Contactless Conductivity Detection

On‐column Conductivity Detection in Capillary‐chip Electrophoresis

Electrochemical Detection Modes for Microchip Capillary Electrophoresis

Design of detection electrode on contactless conductivity detection in capillary electrophoresis microchip

Electrophoretic chip based on special wettability surfaces for detection of heavy metals

A Three-Layer PMMA Electrophoresis Microchip with Pt Microelectrodes Insulated by a Thin Film for Contactless Conductivity Detection

Rapid prototyping of polymeric electrophoresis microchips with integrated electrodes for contactless conductivity detection

A Novel Planar Grounded Capacitively Coupled Contactless Conductivity Detector for Microchip Electrophoresis

An integrated capillary electrophoresis-amperometric detection chip with replaceable and quasi-self-aligned working electrode