Abstract:Honing is an important technology for machining onboard system parts. The parts are usually made of difficult-to-machining materials, e.g., Inconel 718 superalloy. Honing can improve the finishing accuracy and surface quality. However, the selection of the honing parameters was primarily based on the results of a large number of experiments. Therefore, the establishment of a reliable model is needed to predict the honed surface roughness and morphology, and offers a theoretical direction for the choice of parameters. In the present study, a numerical simulation model was constructed for analysis of the honing process by Python. The oilstone, workpiece surface morphology and motion trajectory were discretized by Python, and the machined surface was obtained by trajectory interference. Firstly, based on the statistical analysis of the surface topography of oilstone, the shape of grains was simplified and the surface topography of oilstone was built accordingly. Then, the initial surface morphology of the workpiece was constructed and the trajectory of grains on the workpiece surface was analyzed, which showed the distribution of the removed material. Meanwhile, the plastic deformation of material was analyzed in the simulation model. The critical depth of three stages of contact between grains and workpiece was calculated by the theoretical formula: scratching, ploughing and cutting. By analyzing the distribution of bulge, the plastic deformation in ploughing and cutting stage was studied. Further, the simulated results of honed surface roughness and morphology were validated and agreed reasonably well with the honing experiment. Finally, the effects of honing process parameters, including grain size, tangential speed, axial speed, radial speed and abrasive volume percentage, on the surface roughness of the workpiece were analyzed by the simulation model.

Study On The Control Techniques And Honing Test Of High Precision Vertical Honing Machine With Double Station

The Ultra-precision Machining Technology and It' Domestic and International Progress

The Control Strategy Study for Hydraulic Shaking Table

The Design Study of Single Plane Vertical Hard Bearing Dynamic Balancing Machine

Research on Control Method for Machining Non-Cylinder Pin Hole of Piston

Research on key technologies of automated balancing machines

Preliminary Exploration on Control Theory of Ultraprecision Stage with Large Travel

Measuring and Controlling System of the Accelerated Bearing Life Tester with Auto-loading

1502 Precision Measurement of Vertical Straightness of a Roll Workpiece on an Ultra-Precision Lathe

Study on Control Algorithm for Micro-line Interpolation End-point

Vibration Analysis and Suppression in Robotic Hole Chamfering Process

Numerical analysis and experimental validation of surface roughness and morphology in honing of Inconel 718 nickel-based superalloy

Study and Development of Automatic Control System for Chamfering Machine Based on PLC

Investigation on formation mechanism of surface texture and modeling of surface roughness with internal gear power honing

Development of the High-speed Sliding-rolling Contact Friction Testing Machine

On-Line Monitoring of the Diamond Turned Surfaces

Design and constant force control of a parallel polishing machine

A sophisticated platform for characterization, monitoring and control of machining

Design and Optimization of the Surface Texture at the Hydrostatic Bearing and the Spindle for High Precision Machining

Research on straightness error detection and quality control of multi-crankshaft bores for large medium speed engine block

Research on the mechanisms of internal gear honing by use of cone-shape honing wheel with tool tilt angle