Abstract:In this paper, the effect of the raw particle size and the annealing process on the compositions, microstructure, mechanical, thermal, and electrical properties of ZnO varistors was investigated using X-ray diffraction, infrared, X-ray photoelectron spectroscopy, scanning electron microscopy, electric field–current density, capacitance–voltage, mechanical, and thermal expansion measurements. Furthermore, the ZnO grain growth mechanism during the annealing process was discussed in detail. Results show that when the raw particle size equaled 90 nm and sintering was performed at 1100 °C for 2 h, the obtained ZnO-based varistors possessed excellent mechanical, thermal, and electrical properties; the E1mA, α, JL, and K values were 1015.3 V mm–1, 37.98, 2.45 μA cm–2, and 1.37, respectively, due to the highest bulk density and the finest uniform particle size distribution. When annealing occurred at 300 °C for three times, values of σf, KIC, E1mA, α, JL, and K reached 175.35 MPa, 1.96 MPa m1/2, 1180.2 V mm–1, 43.58, 2.15 μA cm–2, and 1.2, indicating improvements of approximately 14.7%, 4%, 16.2%, 14.7%, − 12.2%, and 11.11% compared with those of the non-annealed ZnO-based varistors, respectively, being due to the improved uniformity of grain size distribution and the re-distribution of donor Al3+ and Y3+ in the ZnO crystal and grain boundary. The annealing process lead to the transformation of Sb3+ to Sb5+ in the ZnO crystal, which could generate two additional coordination sites. The newly generated sites could combine with O2- in other crystals to increase the grain growth, resulting in clear grain growth on the surface, improved grain size distribution, and regular grain shape in the interior of ZnO-based varistors.

Effects of Heat Treatment on the Varistor Performance of ZnO Thin Films Deposited at Low Temperatures

Preparation and characterization of low voltage ZnO film varistor

Influence of Heat-treatment on ZnO-Bi2O3 Based Varistor Ceramics Doped with Rare Earth Oxides

The Effect of DC degradation and heat-treatment on defects in ZnO varistor

The Influence of Heat-Treatment on the Current-Voltage Behavior of the Zno-Bi2o3 Based Varistors

Effects of raw particle size and annealing on microstructure, electrical and mechanical behaviors of ZnO-based varistors

Structures, Varistor Properties, and Electrical Stability of Zno Thin Films

Effects of Annealing Process on Characteristics of Fully Transparent Zinc Tin Oxide Thin-Film Transistor

Effects of Growth Temperature and Annealing on Properties of Zn3sn2o7 Thin Films and Application in Tfts

Effects Of Rapid Thermal Annealing On The Structural, Electrical, And Optical Properties Of Zr-Doped Zno Thin Films Grown By Atomic Layer Deposition

DC Degradation of ZnO Varistor and Its Restorability by Heat-Treatment

Optimization of Sintering Temperature and Doping Level of Cr2O3 in ZnO-Pr6O11-Based Varistor Ceramics

Structural and electrical properties of ZnO–V2O5–TiO2–Co2O3–MnO varistor ceramics with low sintering temperature

Effect of treatment process on the structure and properties of Sr 0.48Ba0.24Ca0.28TiO3-based varistor ceramics

An ultralow concentration of Cr2O3 dopants driven lower temperature sintering ZnO‐based varistor ceramics

Influence of Grain Size on Distribution of Temperature and Thermal Stress in ZnO Varistor Ceramics

Effect of Annealing Temperature on the Electrical Properties of ZnO Thin-Film Transistors

Elaboration and electrical characterization of ZnO-based varistor ceramics in different sintering temperatures

Effect of Treatment Process on the Structure and Properties of Sr<sub>0.48</sub>Ba<sub>0.24</sub>Ca<sub>0.28</sub>TiO<sub>3</sub>-Based Varistor Ceramics

Sandwich-structured ZnO-MnO2-ZnO thin film varistors prepared via magnetron sputtering