Abstract:Stress‐strain analysis in multiple thermal cycles of Cu on AMB‐SN substatre. The active metal brazing of a Si3N4 substrate with Cu has been evaluated for excellent reliability, demonstrating durability up to 1000 cycles in a cycling test ranging from −40°C to 250°C. While the finite element method (FEM) is commonly used for predicting thermal stress–strain in cyclic tests, experimental data on the measurement of thermal stress–strain on metallized substrates have remained limited. In this study, a digital image correlation (DIC) method was employed for the in situ measurement of thermal strain on a fully Cu‐coated Si3N4 substrate (AMB‐SN substrate) in various consecutive thermal cycles, ranging from 1–2 to 199–200. The thermal strains exhibited hysteresis curves that expanded slightly with cycles. By incorporating the coefficients of thermal expansion (CTE) of plain Cu and Si3N4, both the thermal stress and strain of Si3N4 and Cu on the AMB‐SN substrate were computed. The stress–strain curves of Cu revealed that the yield stress of Cu increased with the number of cycles, attributed to the cyclic hardening of the Cu layer. The Cu stress–strain curve calculated in this work showed a good agreement with the previous results obtained from compression/tension test of Cu at room temperature, which indicates the stress–strain curve of Cu on the composite was not sensitive to the temperature during the thermal cycle.

Internal Stress and Yield Strength of Copper Films on Substrates

Relationship Between the Yield Strength and Annealing Temperature of A Cu Film Adherent to Substrate

Study on the Mechanism and Measurement of Stress of Tio2 and Sio2 Thin-Films

Xrd Characterization of Texture and Internal Stress in Electrodeposited Copper Films on Al Substrates

CHARACTERISTIC OF INTERNAL STRESS AND TEXTURE IN ELECTROPLATED COPPER THIN FILMS

Internal Stress in Cu, Ag and Ni Films on Stainless Steel and Ti Substrates

Yield strength calculated by finite element method for sputtered Cu film

Determination of residual stresses in Cu and Ag films on stainless steel substrates by cantilever beam method

Externally Applied Stress Sign and Film Elastic Properties Effects on Brittle Film Fracture

Texture of Electroplated Copper Film under Biaxial Stress

Determination of yielding and debonding in Al–Cu thin films from residual stress measurements via diffraction

Stress–strain behavior of Cu on the AMB‐Si3N4 substrate undergoing thermal cycles via in situ strain measurement

Investigation on Internal Stress of SU-8 Photoresist Film

Yield Strength Determination of TiN Film by In-Situ XRD Stress Analysis Method

A Method of Studying the Effect of Stress and Thermal-stress Coupling on the Thermal Conductivity of the Film

Plane-strain Bulge Test for Nanocrystalline Copper Thin Films

Surface Morphology Anisotropy and Stress Distribution Uniformity in Annealed Cu–W Films

Effect of residual stress on fracture properties of thin films under bending

Thickness Dependent Critical Strain in Submicron Cu Films Adherent to Polymer Substrate

Strain Rate Sensitive Stretchability and Fracture Behavior of Nanocrystalline Cu Films on Flexible Substrate

Fatigue-free Cu films on wrinkled soft substrates