Abstract:As MOSFET devices are scaled down to below 100nm, the gate oxide thickness is required below 2nm. Conventional SiO2 gate dielectric will be replaced due to excessive leakage and poor reliabilit y. Thus, high dielectrics constant (K) gate dielectrics are being studied as an alternative. High-K dielectrics materials such as CeO2, Y2O3, Ta2O5, HfO2, ZrO2, TiO2, Al2O3, SrTiO3(STO), and BaSrTiO3(BST) have are studied . Among them, HfO2 is a promising candidate due to its thermodynamic stabil ity on Si, high dielectric constant ( 25), and relatively large band gap (5.68eV). In the paper, ultra-thin HfO2 gate dielectrics films were fabricated, electrical and reliabili ty properties such as capacitance-voltage (C-V), current-voltage (I-V), stress induce leakage current (SILC) effects and breakdown characteristics were studied. In the experiment, HfO2 capacitor samples have been fabricated using the following process. P-type (100) sili con substrates with 5-8 cm resistivity were cleaned using H2SO4:H2O2 (2:1) solution and HF dip. Thin HfO2 layers were following deposited at room temperature by ion beam sputtering a sintered HfO2 target. Then they were annealed under various temperatures and ambient. After annealing, Pt top electrodes were deposited by sputtering. The area of the capacitors was 5 10cm. The C-V and I-V curves were measured using HP4156B semiconductor parameter analyzer and Keithley590 C-V analyzer. Figure 1 shows the capacitance-voltage (C-V) curves of HfO2 gate dielectrics. The largest value of measured capacitance density in accumulation is Cmax/A=11.6fF/ m. The equivalent oxide thickness (EOT) is about 2.9nm. Comparing capacitances of various annealing temperatures, the capacitance of the sample annealed at 400 is highest. With increase annealed temperatures, EOT increased. Figure 2 shows the current-voltage (I-V) characteristics of HfO2 gate dielectrics. The leakage current of the sample annealed at 800 is lowest, which is about 3.09 10A/cm at –1.5V gate voltage. No distinct SILC effect is obtained. The leakage current of the sample annealed at 400 after 1×10C/cm stress has a very lit tle diversification. With increase annealed temperatures, the leakage current and SILC effect reduced. Figure 3 shows breakdown characteristics of HfO2 dielectrics. The breakdown electric field of HfO2 dielectrics is more than 2×10MV/cm. With increase annealing temperatures, the breakdown voltages decreased. Consequently, ultra-thin HfO2 gate dielectrics (EOT<3nm) were fabricated. All samples annealed under various temperatures and N2 ambient have good electrical characteristic and reliabili ty. With increase annealing temperatures, EOT of increased, the leakage current and SILC effect reduced, the breakdown voltages decreased. References: [1] E.P. Gusev, E. Carier, D.A. Buchanan, M. Gribelyuk, M. Copel, H. Okorn-Schmidt, and C.D. Emic, Microelectronic Engineering 59(2001) 341-349 [2] Wen-jie Qi, Renee Nieh, Byoung Hun Lee, Laegu Kang, Yongjoo Jeon, and Jack C. Lee, Applied Physics Letters, 2000, 77(20): 3269-3271 [3] G.D. Wilk, and R.M. Wallace, Applied Physics Letters, 1999, 74(19): 2854-2856 [4] Kevin X. Zhang, Carlton M. Osbun, IEEE Trans. Electron Devices, 42(12), 1995, 2181-2188 [5] G.D. Wilk, R.M. Wallace, J.M. Anthony, Applied Physics Review, 2001, 89(10): 5243-5275

Thermal Stability and Electrical Properties of Pulsed Laser Deposited Hf–aluminate Thin Films for High-K Gate Dielectric Applications

Comparative Study of Pulsed Laser Deposited HfO 2 and Hf–aluminate Films for High- K Gate Dielectric Applications

Microstructure, Optical, Electrical Properties, and Leakage Current Transport Mechanism of Sol–gel-Processed High-K HfO2 Gate Dielectrics

Microstructure, Optical and Electrical Properties of Sputtered HfTiO High-K Gate Dielectric Thin Films

Annealing Temperature Dependence on the Structural and Optical Properties of Sputtering-Grown High-K HfO2 Gate Dielectrics

Fabrication and Characterization of Pulsed Laser Deposited Hfo2 Films for High-K Gate Dielectric Applications

Modulation of Interfacial and Electrical Properties of ALD-derived HfAlO/Al2O3/Si Gate Stack by Annealing Temperature

Phase Separation and Interfacial Reaction of High-K HfAlOx Films Prepared by Pulsed-Laser Deposition in Oxygen-Deficient Ambient

Comparison of Hfalo, Hfo2/Al2o3, and Hfo2 on N-Type Gaas Using Atomic Layer Deposition

Structure and dielectric properties of Zr-Al-O thin films prepared by pulsed laser deposition

Thermal and Voltage Instabilities of Hafnium Oxide Films Prepared by Sputtering Technique

Fabrication and Characterization of Zr-Rich Zr-Aluminate Films for High-Kappa Gate Dielectric Applications

Fabrication and characterization of La-doped HfO2 gate dielectrics by metal-organic chemical vapor deposition

Properties of high-k gate dielectric LaAlO3 thin films

Temperature Dependent Interfacial and Electrical Characteristics During Atomic Layer Deposition and Annealing of HfO2 Films in P-Gaas Metal–oxide–semiconductor Capacitors

Electrical and Reliability Characteristics of High-Κ HfO 2 Gate Dielectrics

Thermal Stability And Electrical Properties Of Titanium-Aluminum Oxide Ultrathin Films As High-K Gate Dielectric Materials

Exploring the influence of Al content on the optical and interface properties of HfAlOx mixed gate dielectric thin films and their applications in MOS devices

Improved thermal stability and electrical properties of atomic layer deposited HfO2/AlN high-k gate dielectric stacks on GaAs

Thermal Stability of ALD Lanthanum Aluminate Thin Films on Si (100)

Characterization of the Interface Between the Hf-based High-K Thin Film and the Si Using Spatially Resolved Electron Energy-Loss Spectroscopy.