Abstract:It is well known that the mechanical properties of spheroidal graphite cast iron deeply depend on the volume of pearlite matrix microstructures. Therefore, the theoretical criterion of pearlite matrix nucleation is considered important in this graphite cast iron that to obtain the higher mechanical properties of graphite cast iron, the pearlite stabilizing element such as Mn or Cu is very important. The present work aims to study the influence of manganese (Mn) content and heat treatment on the mechanical properties of 3% or 4% (Solution Strengthened Ferritic Ductile Iron-SSFDI) of silicon (Si) containing spheroidal graphite cast irons. The six 3.6%C–3%Si melts with different chemical compositions from 0.2 to 1.7 mass% of Mn content were produced using a high-frequency induction furnace. The melt was poured into a Y-block CO 2 sand mold of 25 or 40 mm in thickness. The microstructure analysis and mechanical testing were performed for as-cast and some heat treatment conditions, such as annealing or air cooling. As a result, the tensile strength had a good relationship with the area fraction of pearlite, over 600 MPa in UTS, and high proof stress for some 3 or 4%Si–Mn series samples in the as-cast condition. By the heat treatment from the unique ( α + γ ) region, the 3% Si sample showed over 800 MPa and over 10% in elongation. And 4%Si–1.5%Mn (SSFDI) series sample showed over 600 MPa in UTS and over 15% in elongation which was prepared by annealing heat treatment to reduce to less than 5% of the area fraction of pearlite. This study suggests that it can be understood of the correlation between optimizing the heat treatment condition and mechanical properties of SSFDI cast irons.

Effect of Sb on the Graphite Morphology and Mechanical Properties in Heavy Section Ductile Iron

Effects of Antimony on Structure and Properties of Vermiculate Cast Iron

Effect of Sulfur on Antimony-Induced High-Temperature Ductility Deterioration of C-Mn Steel

The Effect of Solution Treatment on the Si Particles’ Morphology Evolution and the Thermal Conductivity and Tensile Properties of Sb-Modified Al-8Si-0.6Mg Alloys

The Effect of Boron (B) and Copper (Cu) on the Microstructure and Graphite Morphology of Spheroidal Graphite Cast Iron

Effects of Alloy Elements on Ductility and Thermal Conductivity of Compacted Graphite Iron

Effects of Manganese and Heat Treatment on Mechanical Properties in Spheroidal Graphite Cast Iron

Effects of graphite nodule count on mechanical properties and thermal conductivity of ductile iron

Tomographical Study Of The Effect Of Graphite On Properties Of Cast Iron

Scanning Auger Microprobe Study of Interfacial Adsorption Behaviour of Some Minor Elements in Spheroidal-graphite Cast Iron

Study on Thermal Simulation of Solidification in Heavy Section Ductile Iron

Development of New Ductile Iron with Super-High Thermal Conductivity and Elongation

Influence of Cu on Properties of High Strength Ductile Cast Iron

Effect of bismuth on the mechanical properties and microstructure evolution of iron matrix during drawing: a molecular dynamics study

Effect of Nb/V Alloying on the Microstructure and Mechanical Properties of SiMo Ductile Iron

Impact of carbide-promoting elements on the mechanical properties of solid-solution-strengthened ductile iron

The Effect of the Substitution of Silicon by Aluminum on the Properties of Lamellar Graphite Iron

Effect of alloying elements W, Ti, Sn on microstructure and mechanical properties of gray iron 220

Effect of Boron and Carbon Content on Microstructure and Properties of High Boron Iron-Based Alloy

Effect of Nb Addition on Compact Microstructure and Mechanical Properties of Gray Cast Iron for Cylinder Liner

Effect of Chromium on Microstructure and Properties of High Boron White Cast Iron