Abstract:The aim of this study was to investigate the low-temperature degradation (LTD) kinetics of tetragonal zirconia with 3 mol% yttria (3Y-TZP) dental ceramic using two degradation methods: hydrothermal degradation and immersed degradation. To study transformation kinetics, we prepared 3Y-TZP powders. We pressed these powders uniaxially into a stainless mold at 100 MPa. We then sintered the compacted bodies at intervals of 50 °C between 1300 °C and 1550 °C and immersed the specimens at various temperatures from 60 °C to 80 °C in 4% acetic acid or from 110 °C to 140 °C for the hydrothermal method. We used a scanning electron microscope (SEM) to confirm crystalline grain size and used X-ray diffraction to analyze the zirconia phase. As the sintering temperature increased, the calculated crystalline grain size also increased. We confirmed this change with the SEM image. The higher sintering temperatures were associated with more phase transformation. According to the Mehl-Avrami-Johnson equation, the activation energies achieved using the hydrothermal method were 101 kJ/mol, 95 kJ/mol, and 86 kJ/mol at sintering temperatures of 1450 °C, 1500 °C, and 1550 °C, respectively. In addition, the activation energies of the specimens immersed in 4% acetic acid were 60 kJ/mol, 55 kJ/mol, 48 kJ/mol, and 35 kJ/mol, with sintered temperatures of 1400 °C, 1450 °C, 1500 °C, and 1550 °C, respectively. The results showed that a lower sintering temperature would restrain the phase transformation of zirconia because of the smaller crystalline grain size. As a result, the rate of LTD decreased.

Effect of Al2O3 on Degradation of 3Y-TZP Ceramics at Low Temperature

[Study on Low Temperature Degradation of Dental Zirconia Ceramic].

Effect of Al2O3 on the Phase Stability of Y-Ce-TZP/Al2O3 Composites at Low Temperature

The Effect of Al2O3 on the Thermal Stability and Mechanical Properties of 3Y-TZP

The Study on Degradation of Y<sub>2</sub>O<sub>3</sub>-CeO<sub>2</sub>-Partially Stabilized ZrO<sub>2</sub> Adding Al<sub>2</sub>O<sub>3</sub> Particles at Low Temperature

Low Temperature Aging Effects of Y_2O_3 Stabilized Tetragonal Zirconia Polycrystals Ceramics in Acidic Environment

Effects Of Sintering Temperature On Degradation Of Al2o3-Y-Ce-Tzp Ceramics At Low Temperature

Evaluation of Feasibility on Dental Zirconia-Accelerated Aging Test by Chemical Immersion Method

Microstructural dependence of aging induced phase transformation in Y2O3 partially stabilized ZrO2 polycrystals

Phase transformation of Y-Ce-TZP/Al2O3 composite ceramic annealed in air

Raman and X-ray photoelectron spectroscopic characterizations of thermal stability of 3 mol% yttria stabilized zirconia ceramics

The Effect of the Additive to the Thermal Shock Resistance of Zirconia

High Temperature Mechanical Properties of Zirconia Metastable T '-Phase Degraded Yttria Stabilized Zirconia

Mechanical, low temperature degradation, and biocompatibility of Al-doped dental 3Y-TZP ceramic

Effects of Low-Temperature Aging on Mechanical Properties of Two Kinds of Dental Zirconia Ceramics

Influence of a small amount of Al2O3 addition on the transformation of Y2O3-partially stabilized ZrO2 during annealing

X‐ray Photoelectron Spectroscopy Investigation on the Low‐Temperature Degradation of 2 Mol% Y2O3‐ZrO2 Ceramics

Effect of thermal treatment at high temperature on phase stability and transformation of Yb2O3 and Y2O3 co-doped ZrO2 ceramics

Microstructural characterization of Ce-TZP/Al2O3 after degradation in water

Resistance to Low‐Temperature Degradation of Equimolar YO1.5–TaO2.5 Stabilized Tetragonal ZrO2 Ceramics in Air

Critical effect of cubic phase on aging in 3 mol% yttria-stabilized zirconia ceramics for hip replacement prosthesis