Effect of Particle Size and Morphology on Microstructure and Properties of Al2O3p/Al Composites
姜龙涛,武高辉,孙东立,张强,陈剑锋,河野纪雄,齐藤秀雄
DOI: https://doi.org/10.3321/j.issn:1004-0609.2002.03.022
2002-01-01
The Chinese Journal of Nonferrous Metals
Abstract:Aluminum matrix composites with alumina particles of 40%(volume fraction) were fabricated using 5.0?μm and 0.15?μm Al 2O 3 particles respectively. The microstructure of the two kinds of composites before and after tension was investigated with transmission electron microscope (TEM). It was found that there was a high dislocation density in the as-cast composite reinforced by 5?μm sharp-angle-shaped Al 2O 3 particles, due to the thermal mismatch stress. In contrast, little dislocation was observed in the as-cast composite reinforced by 0.15?μm spherical Al 2O 3 particles, which could be attributed to the following factors, such as the dispersion of the equiaxed fine particles, uniform distribution of the stress near the interfaces, etc. The microstructural observation near the fracture indicated that dislocations increased in the matrix of the former composite, while obvious dislocation loops were found in the latter. The room temperature tensile test confirmed that such microstructure in the sub-micro Al 2O 3p/Al composites was beneficial to an increase in their strength and ductility.