Abstract:The laminar flame speeds of H2/CO/air mixtures with N2 and CO2 dilution were experimentally and numerically studied over a wide range equivalence ratios (0.8–4.0) with N2 (dilution ratio 0–150 vol%) and CO2 (dilution ratio 0–66.7 vol%) dilution in the fuels. The experimentation was conducted using the Bunsen flame method incorporating the Schlieren technique, and the corresponding cases were computed using Chemkin-Pro with four different reactions mechanisms, viz, Li-Mech, Frassoldati-Mech, Davis-Mech and Keromnes-Mech. To eliminate the flame stretch effect on the laminar flame speed measurement based on the Bunsen flame method, a non-linear extrapolation approach was proposed and proved to give comparable accuracy with those from the stretch-corrected spherical flame and counterflow flame methods. A comparison between the experimental and numerical results showed that Davis-Mech and Li-Mech provided better estimates of the laminar flame speed. Keromnes-Mech over-estimated the laminar flame speed especially for fuel-rich mixtures. Meanwhile, Frassoldati-Mech under-estimated the laminar flame speed when the H2 content was high and the disparity decreased as the dilution ratio increased. Detailed analysis of the computation results indicated that the accurate prediction of H and OH mole fractions was crucial to the calculation of laminar flame speeds of H2/CO/air mixtures with N2 and CO2 dilution. CO2 exhibited a stronger dilution effect than N2 due to CO2's stronger thermal and chemical kinetic effects in reducing the flame temperature and radical concentrations. The preferential importance of the thermal, direct reaction and the third body effects caused by the dilution was addressed using numerical computation with two artificially created species. The results revealed that the thermal effect, i.e., the flame temperature reduction by the dilution, dominated the reduction of laminar flame speed, especially under high dilution conditions.

Mixing Characteristics of Gaseous Fuel in Vapor Flame Holder and Discharge Coefficient of Evaporating Pipe

Characteristic Analysis of Low-Velocity Gas Filtration Combustion in an Inert Packed Bed

Lift-off Flames of Propane under a Variety of Co-Flow Conditions

Combustion Instability and Emission Characteristics of Spray Flame under Flue Gas Jet

Effects of Reactant Injection Conditions on Diffusion Combustion of Natural Gas in a Laboratory-scale Combustor

DEM–CFD Simulation of the Particle Dispersion in a Gas–solid Two-Phase Flow for a Fuel-Rich/lean Burner

Effects of Equivalence Ratio and Premixing Pattern on Flameless Combustion

Combustion Characteristic and Mechanism of a Mixture Working Fluid C3H8/CO2

A Study of Combustion Technology Featuring the Pulsating Feed of Fuel and the Influence Exerted by Various Parameters

Experimental Research on Using CO2-Ar Microjets to Control Liquid Fuel Combustion Instability and Pollutant Emission

Experimental study on flow field and combustion characteristics of V-gutter and integrated flameholders

Study on the formation and maintenance mechanism of the stationary flame at the head of a LOX/GCH4 pintle injector element

Study on Laminar Flame Characteristics of H2/CO/O2/CO2 Mixtures at Different Preheating Temperatures

Experimental Investigation of Coflow Effect on the Ignition Process of a Methane Jet Diffusion Flame

Simulation of DME-O2 Combustion in a Hollow Cone Impinging Jet Combustor for Direct-Fired Supercritical CO2 Power Cycle

The experimental study of flame height and lift-off height of propane diffusion flames diluted by carbon dioxide

Laminar Flame Speed of CO2 and N2 Diluted H2/CO/air Flames

Diffusion Flame of A Ch4/H-2 Jet in Hot Low-Oxygen Coflow

THE DIFFUSION CHARACTERISTICS OF THE HORIZONTAL FUEL RICH-LEAN GAS-SOLID BURNER FLOW

Flow Behavior of High-Temperature Flue Gas in the Heat Transfer Chamber of a Pilot-Scale Coal-Water Slurry Combustion Furnace

Suppression of Combustion Instabilities of Swirled Non-Premixed Liquid-Fuel Flame with CO2–O2 Jet in Cross-Flow