Abstract:The transition section between bottom dense zone and top dilute zone is important for fast gas-solids catalytic reactions,such as methanol to olefins(MTO).Solids concentration and fluctuation parameters in the transition section of a fluidized bed with 95 mm i.d.were measured by using reflective optical fiber probe(PV6D).The influences of superficial gas velocity and static bed height were investigated.An Eulerian-Eulerian two-fluid model that incorporated kinetic theory of granular flow and modified three-zone drag law was used to predict the flow structure in the turbulent fluidized bed.The axial and radial distributions of solids concentration were simulated by means of computational fluid dynamics(CFD).The experiments showed two axial profiles of solids distribution in the transition section:exponential and S-shaped.The maximum gradients of both axial and radial solids concentration profiles were located in the transition section,which meant that solids distribution in the transition section was much more non-uniform than that in the dilute and dense sections.The change of gas velocity and static bed height would cause a shift between exponential and S-shaped profiles,and significantly affect solids concentration in the dense region near the wall and at the bottom.Probability density distribution of local solids concentration revealed that when static bed height was small,the location of maximum voidage would gradually move from core region to annular region with increasing gas velocity,resulting in a bimodal distribution of voidage.A modified three-zone drag model was proposed by taking the effect of particle clustering into account for CFD simulation.The simulated solids concentration distribution agreed well with experimental data in the transition section except for the distributor zone.

An Automatic Method for Measuring Solids Flux in High Density Gas-solids Two-phase Flow

Experimental and numerical investigation of solid behavior in a gas–solid turbulent fluidized bed

Particle Velocity Measurements in Transition Section of Turbulent Fluidized Beds Using Optical Fiber Probe and CFD Simulation

Experimental and Numerical Study of Solids Concentration Distribution in Transition Section of Turbulent Fluidized Bed

Dynamic and Steady-State Characterization of the Liquid Spray Zone in an Externally Heated Gas–Solid Fluidized Bed

Simultaneous Measurement of Electrostatic Charge and Its Effect on Particle Motions by Electrostatic Sensors Array in Gas-Solid Fluidized Beds

Soft-sensing System of Gas-Solid Fluidized Bed

Measurement of Flow Pattern in Fluidized Bed Based on Acoustic Emission and Complexity Analysis

Measurement of Flow Pattern and Bed Level of Gas-solid Fluidized Bed in Borstar Process by Acoustic Emission Technique

Detection of Particle Mass Flowrate in High-Speed Fluidization Based on Acoustic Emission Technology

Online Measurement of Particle Charge Density in A Gas-Solid Bubbling Fluidized Bed Through Electrostatic and Pressure Sensing

Particle Fluidization Characteristics and Transition in a Hot Gas-Solid Fluidized Bed with Liquid Injection

Measurement of Bed Level in Gas-Solid Fluidized Bed by Ultrasonic Technique

Experimental and Modeling Investigation of Liquid-Induced Agglomeration in a Gas–Solid Fluidized Bed with Liquid Spray

Experimental Research on the Gas-Solid Flow Characteristics in Large-Scale Dual Fluidized Bed Reactor

Solids mass flux and mean dynamic solids hold-up in the packed section of the gas-solid-solid circulating fluidized bed

Algorithmic Complexity of Information Transport among Multiple Sensors in Gas-solid Fluidized Beds

Investigation of Flow Rate Measurement Method in Gas-Liquid Two-Phase Flow with High Gas Volume Fraction

Mass flux profiles and flow regimes in a high density circulating Fluidized bed

Measurement of Acoustic Emissions and Flow Pattern in Gas-Solid Fluidized Bed

Measurement of two phase flow concentration with a novel pressure difference method. I: Principle