Abstract:The mechanical and twinning behavior of Mg alloys containing a monolithic texture component have been extensively studied; however, studies on samples with multi texture components are much insufficient. In this study, the quantitative relationship between the mechanical behavior under tension along the extrusion direction (ED) of Mg AZ31 rods and the percentages of bimodal texture components <0002>// ED (19–87%) and <0002>⊥ED were systematically studied. The component <0002>// ED favors <math>{101¯2}</math> twinning and is soft orientations; however, the component <0002>⊥ED favors prismatic slip and is hard orientations. The results show that the yield strength does not decrease linearly with an increase in the percentage of the soft orientations and show a deviation from the calculations using the conventional rule of mixtures. A higher percentage of the soft grains increases this deviation when the percentage is below 50%, and decreases it over 50%. The ultimate strengths, however, do not show an obvious dependence on the percentage of the soft orientations. Subsequently, the corresponding mechanisms are discussed and a modified rule of mixtures was developed. Bimodal texture components stimulate the activation of <math>{101¯2}</math> twin variants with a low Schmid factor and the presence of more variants within one grain. Conventional strain accommodation rule was used to analyze this twinning behavior, but it cannot explain the experimental observations. Crystal-plasticity based finite element modeling was employed to analyze this strange twinning behavior. The results indicate that the interaction among twin variants, rather than deformation in neighboring grains, plays a major role in the activation of twins with a low Schmid factor, due to a hard deformation propagation from the soft grains to the hard grains. This finding provides an important complementation to the strain accommodation theory.

Effects Of Texture On The Shear Strength Of In Bump

Effect of the Texture of Indium on Its Mechanical Properties

Effects of shear test temperatures and conditions on mechanical properties of Sn–Ag flip-chip solder bumps

Numerical study on mechanical properties of grains in rock discontinuity undergoing shear

Effects of microstructure and texture on the deep drawability of C10200 copper sheets

Changing Mechanism of Microstructure of Intact Soft Clay Considering Anisotropy

Influence of crystallographic texture on Young's modulus of various Alloy 82H welds

Effects of texture spacing and bulges of bionic sinusoidal texture on the adhesion properties and fracture mechanism of plasma-sprayed coatings

A quantitative study on mechanical behavior of Mg alloys with bimodal texture components

Effect of compressive load on texture evolution and anisotropic behavior of dual-phase steel under biaxial loading in complete σ 11 -σ 22 space

Effect of texture on grain growth in an interstitial-free steel sheet

Determination of the macroscopic residual stress: Modeling and experimental evaluation of texture and local grain-interaction

Effect of texture on damping behaviour in ZK60 magnesium alloy

Effect of texture types on microstructure evolution and mechanical properties of AZ31 magnesium alloy undergoing uniaxial tension deformation at room temperature

Investigation of powder flowability at low stresses: Influence of particle size and size distribution

Evolution of the Texture and Mechanical Properties of 2060 Alloy During Bending

Texture development and mechanical behavior of Zircaloy-4 alloy plates fabricated by cold rolling and annealing

Effect of uniaxial loading direction on mechanical responses and texture evolution in cold pilgered Zircaloy-4 tube: Experiments and modeling

EFFECT OF INTERMEDIATE DEFORMATION ON THE TEXTURING OF <font>Bi</font>-2223/<font>Ag</font> TAPES

Effect of Cementation Degree on Shear Characteristic and Failure Mechanism of Bimrocks Containing Gravels of Different Sizes

Texture Evolution and Their Effects on the Mechanical Properties of Duplex Mg–Li Alloy