Abstract:A hollow cylinder apparatus is used to carry out tests on the principal stress axis rotation for Hangzhou intact soft clay under consolidated undrained conditions, and complex stress path under axisymmetric and three-dimensional stress state is designed. The theoretical results about the impact of rotation rate of the principal stress axis, coefficient of the intermediate principal stress and the initial shear stress on the pore pressure characteristic is validated in tests. The theoretical analyses and test results reveal that the deformation of specimens and the increment of pore pressure generated in the rotation rate of the principal stress axis between 0 and 45 degrees are different from those in the rotation rate of the principal stress axis between 45 and 90 degrees during the rotation of the principal stress axis, and the rotation rate of 45 degrees is the cut-off point. When the coefficient of the intermediate principal stress changes between 0 and 1, the increment of the pore pressure generated decreases first and then increases with the increase of the coefficient of the intermediate principal stress, and the coefficient of 0.5 is the cut-off point, and the impact of the coefficient of the intermediate principal stress on the pore pressure generated is controlled by the level of shear stress in the shearing process. The higher the initial shear stress, the greater the increment of the pore pressure generated in the increasing stage of the initial shear stress and the higher the overall level of the pore pressure in the shearing process. The angle of the major principal stress direction as the control conditions will generate more increment of pore pressure than the initial shear stress as the control conditions in the initial stage of shear stress path including the rotation of the principal stress axis and the increase of the shear stress, and it has a greater impact on the pore pressure generated in the shearing process.

Changing Mechanism of Microstructure of Intact Soft Clay Considering Anisotropy

Microstructure Behavior Of Intact Soft Clay After Principal Stress Rotation

Microstructure Study on Intact Clay Behavior Subjected to Cyclic Principal Stress Rotation

Effects of inherent and induced anisotropies on strength and deformation characteristics of soft clay

Study Of Microstructures Of Soft Clay Under Dynamic Loading Considering Effect Of Cyclic Stress Ratio And Frequency

Microstructural Change Of Clay Under Compression

Impact of Shear Stress on Strain and Pore Water Pressure Behavior of Intact Soft Clay under Principal Stress Rotation

Study of Failure Criterion for Hangzhou Intact Soft Clay under Complex Stress Path

Deformation of Intact Soft Clay under Principal Stress Rotation with Effect of Intermediate Principal Stress

CHARACTERISTICS OF PORE WATER PRESSURE OF INTACT SOFT CLAY UNDER ROTATION OF PRINCIPAL STRESS AXES AND INTERMEDIATE PRINCIPAL STRESS COEFFICIENT(b) OF 0.5

Experimental Study of Stress-Strain Properties of Intact Soft Clay Considering the Change of Principal Stress Direction

Influencing Factors about Pore Pressure Generated for Clay under Complex Stress Path

STUDY OF INFLUENCE OF PARAMETERS OF INTERMEDIATE PRINCIPAL STRESS AND PRINCIPAL STRESS DIRECTION ON ANISOTROPY OF INTACT CLAY

Research on influence of principal stress axis cyclic rotation at low shear stress level on behavior of intact clay

Undrained Anisotropy and Non-Coaxial Behavior of Clayey Soil under Principal Stress Rotation

Effect of Anisotropic Consolidation Stress Paths on the Undrained Shear Behavior of Reconstituted Wenzhou Clay

COUPLING EFFECTS OF INITIAL SHEAR STRESS AND LOADING RATE ON STRENGTH BEHAVIORS OF SATURATED SOFT CLAY

Study On Strength Criterion Of Intact Soft Clay After Monotonic Principal Stress Rotation

Intact soft clay’s critical response to dynamic stress paths on different combinations of principal stress orientation

Effects of Initial Shear Stress on Cyclic Behavior of Saturated Soft Clay

Anisotropic and Noncoaxial Behavior of K0-Consolidated Soft Clays under Stress Paths with Principal Stress Rotation