Abstract:Microstructure behavior of Hangzhou intact soft clay after principal stress rotation test was studied. Macroscopic mechanical tests were performed by using ZheJiang University Hollow Cylinder Apparatus (ZJU-HCA). To fully investigate the geometric variation of micro-porosity, SEM images of the samples were taken from three different planes, i.e., horizontal, radial and tangential plane. Pores (Particles) and Cracks Analysis System (PCAS) was used for analysis soil microstructure variation. The results show that in fixed principal stress direction tests with the increase of rotation angle, pores arrangement has best ordering at alpha=60 degrees in all three observed planes, which are close to the results of macroscopic tests about the compressibility. Also, the variation of pores arrangement is more obvious in radial plane, while the change range of pores morphology is greater in horizontal plane, and the change of pore scale mainly occurred in horizontal and radial plane. These differences of the changes of pore microstructure in different observed planes are consistent with the anisotropy behavior since when the coefficient of intermediate principal stress equal to 0.5, the soil does not have transverse isotropic along the direction of sedimentary. In pure principal stress rotation tests, the variations of pore size, orientation, and morphology mainly occur in radial and tangential plane, while no obvious changes are observed in horizontal plane. These microstructure characteristics demonstrate that significant variation happens in vertical plane rather than the horizontal plane which echoes the fact that the principal stress axis rotates in vertical plane. This study will be of great importance in understanding soil behavior in principal stress rotation test.

Study Of Microstructures Of Soft Clay Under Dynamic Loading Considering Effect Of Cyclic Stress Ratio And Frequency

Microstructure Study on Intact Clay Behavior Subjected to Cyclic Principal Stress Rotation

Dynamic characteristics of isotropically consolidated intact soft clay and study of pore water pressure based on energy method under wave loading

Microstructural Change Of Clay Under Compression

Microstructure Behavior Of Intact Soft Clay After Principal Stress Rotation

Intact soft clay responses to cyclic principal stress rotation in undrained Condition

Deformation of overconsolidated soft clay considering initial shear stress and frequency

STUDY ON STRAIN SOFTENING IN SATURATED SOFT CLAY UNDER CYCLIC LOADING

Degradation of Dynamic Elastic Modulus of Soft Clay under Cyclic Loading

Study on dynamic stress-strain relationship of soft clay considering degradation of stiffness under cyclic loading

STUDY ON ACCUMULATIVE PLASTIC STRAIN MODEL OF SOFT CLAY UNDER CYCLIC LOADING

Influences of Stress Magnitude and Loading Frequency on Cyclic Behavior of K0-consolidated Marine Clay Involving Principal Stress Rotation

Study on dynamic behaviors of soft clay under bidirectional cyclic loading

STUDY ON STRENGTH AND DEFORMATION BEHAVIORS OF SOFT CLAY UNDER BIDIRECTIONAL EXCITING CYCLIC LOADING

Stiffness Degradation and Plastic Strain Accumulation of Clay under Cyclic Load with Principal Stress Rotation and Deviatoric Stress Variation

Effects of principal stress rotation and cyclic confining pressure on behavior of soft clay with different frequencies

Microstructure Investigation of Soft Clay Subjected to Triaxial Loading

Experimental Study on Degradation of Stiffness of Saturated Soft Clay under Undrained Cyclic Loading

Effects of Initial Shear Stress on Cyclic Behavior of Saturated Soft Clay

Influence of Shear Stress Level on Cyclic Deformation Behaviour of Intact Wenzhou Soft Clay under Traffic Loading

Cyclic Behavior of Saturated Soft Clay under Stress Path with Bidirectional Shear Stresses