Abstract:NOx control by catalytic oxidation combined with wet absorption has been a promising technology for the flue gas treatment of industrial boiler and furnace. LaMnO3+delta perovskites were investigated as catalysts for NO oxidation. The comparison between metal substitution of La and Mn cations was researched. The activity results indicated that La site substitution was more favorable for NO oxidation than Mn site substitution. LaCoMnO exhibited the highest activity in NO oxidation with maximum value of 83.74% at 250 degrees C. That value further increased to 89.96% after acid etching (LaCoMnO-A), and closely, such high value of 89.78% was achieved at 220 degrees C. The surface area was significantly improved by acid etching, i.e., from 47.0 m(2)/g to 212.0 m(2)/g, Tremendous changes in crystalline structure and morphology were taken place, i.e., perovskites phase disappeared and MnO2 was detected instead; compact amorphous particle morphology was replaced by multiple layer structure. Even more, Mn4+ ions and oxygen vacancies accumulated on the surface were improved. Deservedly, the redox property was enhanced enormously, especially at low temperature. Subsequently, SO2 poisoning tests were conducted at 250 degrees C under 20 ppm SO2. Interestingly, no decrease was observed for LaCoMnO-A within 480-min SO2 poisoning test, which was totally contrasted with the nearly complete deactivation results of LaCoMnO. In-situ DRIFTS measurements validated nitrate disappeared and replaced by sulfate formation on the catalyst surface. Merely, under low-concentration SO2 atmosphere, the monodentate nitrate and bidentate nitrate were destroyed, while the free nitrates exhibited higher resistance. Overall, the acid etching improved the catalyst resistance to SO2, which may have the potential to apply in the flue gas treatment of low-sulfur and sulfur-free fuel fired boiler and furnace.

Surface characterization and catalytic performance of La0.7 Sr0.3MnO3+λ coating deposited by plasma spraying

Deposition of Selective Catalytic Reduction Coating on Wire-Mesh Structure by Atmospheric Plasma Spraying

Characterization of the Microstructure and Electrical Conductivity of Plasma-Sprayed La0.5Sr0.5CoO3 Coating

Influence of Partial Mn-substitution on Surface Oxygen Species of LaCoO3 Catalysts

Facile One-Step Flame Synthesis of La1−xSrxMnO3 Nanoparticles for CO Catalytic Oxidation

Surface tuning of noble metal doped perovskite oxide by synergistic effect of thermal treatment and acid etching: A new path to high-performance catalysts for methane combustion

Enhancement of NO Oxidation Activity and SO2 Resistance over LaMnO3+δ Perovskites Catalysts with Metal Substitution and Acid Treatment

Investigation on the Catalytic Combustion of CO over LaMn 1‐ X Cu X O 3 Promoted by Acid Treatment

Catalytic performance of rare earth nanometer materials LaMnO3+lambda

Investigation of Flame Spray Synthesized La1-xSrxCoO3 Perovskites with Promotional Catalytic Performances on CO Oxidation

Plasma spray coating on interconnector toward promoted solid oxide fuel cells and solid oxide electrolysis cells

Structure and performance of γ-alumina washcoat deposited by plasma spraying

Plasma-reconstructed LaMnO 3 nanonetwork supported palladium catalyst for methane catalytic combustion

Promoted Platinum Catalytic Activity and Thermal Stability with Nano-Scale Cobalt Oxide Coating Via Atomic Layer Deposition

The Microstructure and Conductivity Evolution of Plasma-Sprayed (Mn, Co)3O4 Spinel Coatings during Conductivity Measurements at Elevated Temperature

Deep Insight into the Mechanism of Catalytic Combustion of CO and CH 4 over SrTi 1– x B x O 3 (B = Co, Fe, Mn, Ni, and Cu) Perovskite via Flame Spray Pyrolysis

Preparation and catalytic activities of Lanthanum strontium manganite based catalysts supported on honeycomb ceramics

Ca-Mn co-doping LaCrO3 coating with high emissivity and good mechanical property for enhancing high-temperature radiant heat dissipation

Mn‐Fe‐Ce Coating Onto Cordierite Monoliths As Structured Catalysts for NO Catalytic Oxidation

Infrared radiation and thermal cyclic performance of a high-entropy rare-earth hexaaluminate coating prepared by atmospheric plasma spraying

CuO modified LaNi0.4Al0.6O3‐δ with improvement performance in MSR at Low Temperature