Abstract:The formation of the surface layer of cast iron during the processing of cast iron in the environment of superheated steam of an aqueous solution of salts is considered. An ecologically cleaner method of chemical-thermal treatment is offered. The article considers the surface layer obtained in the environment of superheated steam of an aqueous solution of water-soluble salts of ammonium molybdic acid. The layer is formed on the surface of the matrix and around the graphite inclusions. The impact of temperature on the formation of a multilayer coating by increasing the temperature in contact with the metal surface is the dissociation of chemical compounds in solution, with the formation of atomic oxygen, sulfur, nitrogen, molybdenum. The formation of the surface layer occurred not only on a metal base, but also on the boundaries of graphite, both lamellar and globular, coming to the surface of the metal without breaking the solid layer. It is established that as a result of interaction of technological parameters of temperature, holding time and concentration of saturated medium graphite in the surface layer changes its shape, becoming spherical, although in the matrix it had a lamellar shape. It is multiphase and contains soft and hard structural components. Comparative studies have shown that the wear rate of untreated cast iron is much higher than that of treated cast iron, and reaches 0.8 ∙ 10-4 μm/km at a load of 400 N. This increases the wear resistance of cast iron and at the same time improves the workability reducing the coefficient of friction. The effect of the coating on the workability show that the stabilization of the friction moment occurs faster in samples with a multilayer coating. Thus, for gray cast iron with lamellar graphite, the stabilization time of the friction moment in a multilayer coating is 0.6 h compared with 2 h for a single layer coating; in high-strength cast iron it is, respectively, 5.2 and 6.3 hours.

Micro-plasma arc surface treatment of gray iron

Effect of plasma-arc scanning on the wear resistance of gray iron

Surface Treatment of 0cr19ni9 Stainless Steel SMAW Joint by Plasma Melting

A Study on the Wear Resistance of Laser Cladding Layers on Grey Iron

Microstructure and high-temperature wear properties of in situ TiC composite coatings by plasma transferred arc surface alloying on gray cast iron

Microstructure and Soil Wear Resistance of a Grey Cast Iron Alloy Reinforced with Ni and Cr Laser Coatings

Wetting and Spreading Behavior of Molten Iron in Contact with Graphite Substrate: Interfacial Effects

Increasing the tribological properties of the sur-face layer of cast iron by treatment in the envi-ronment of overheated steam of aqueous solution

Microstructure and mechanical properties of surface layer of M50NiL steel plasma nitrided

TiC Reinforcement Composite Coating Produced Using Graphite of the Cast Iron by Laser Cladding

Surface characteristic and wear resistance of QT-700-2 nodular cast iron after laser quenching combing with shot peening treatment

Study on the Microstructure of White Layer during Precision Hard Part Machining

Surface Physical and Chemical Modification of Pure Iron by Using Atmospheric Pressure Plasma Treatment

Surface modification of ultrahigh strength 300M steel under supercritical carbon dioxide (scCO2)-assisted grinding process

Surface Residual Stress and Friction Wear Behavior of Vermicular Graphite Cast Iron after Laser Remelting

Effect of cooling conditions on microstructure evolution and wear behavior of high chromium cast iron hardfacing layer

Investigation on Microstructures and Tribological Characteristic of Laser Remelting Layers

The Preparation, Microstructure, and Wet Wear Properties of an Fe55-Based Welding Layer with the Co-addition of 0.01wt% CeO2 and 1.5 wt% SiC Particles Using the Plasma Beam Spraying Method

Crack resistance and wear resistance of laser clad layer on the surface of cast iron

Comparative study on microstructures and properties of air-cooled and water-cooled Fe-based plasma arc cladding layers