Abstract:The Lebowitz solution of the Percus-Yevick hard-sphere mixture is invoked with the square-well potential function to determine Ashcroft-Langreth type three partial correlation functions in binary Cu-In liquid alloys. These computed partial correlation functions have been employed to generate Bhatia-Thornton fluctuations in the considered melts. Using these structural parameters we investigate the temperature and composition-dependent diffusion coefficients of considered melts. The computed values of concentration-concentration fluctuations, in the long-wavelength limit and the Warren-Cowley short-range order parameter, show the formation of chemical compounds between unlike atoms in the In-rich region of Cu-In melts. We find a very good agreement between theoretically formulated and computed data of with the corresponding experimental values. Computed results of and suggest that hetero coordination is favorable over homo coordination in the investigated melts. The validity of the Stokes-Einstein relation was observed over a wide range of temperature and composition in the investigated melts. Further, a new correlation between two body pair excess entropy and the Stoke-Einstein relation has been formulated for square-well binary liquid alloys. Surface tension and compressibility as a function of In composition have been computed through microscopic structural functions of the alloys. Computed , , surface tension and ratio of mutual to intrinsic diffusion (Dm/Did) are found comparable to available simulated data. The computed values of shear viscosity are in good agreement with the experimental data. Calculated results suggest that the combination of hard sphere potential with square-well tail under mean spherical model approximation is one of the good method for determining the structures and transport coefficients of compound forming binary liquid alloys.

Correlation Between Microstructure and Composition of Cu-In Alloy

Phase and microstructure evolution in Cu-In-Cr alloys

Influence of Chromium Content on Microstructure of Cu-ln-Cr Ternary Alloy

Microstructure evolution and properties of Cu–Ag microcomposites with different Ag content

Strain Compatibility Behavior in Cu-6%Ag Alloy During Drawing into Filamentary Structure

Effects of Cu on the High-Entropy Alloys of CuxCoCrFeNi: Experiment and Molecular Dynamics Simulations

Effects of Indium on Corrosion Behavior of Mg-Al-Cu Alloy

Effects of Cu Addition on the Microstructure and Properties of the Al–Mn–Fe–Si Alloy

Microstructure and phase components of the as-cast Cu-0.4%Cr-0.12%Zr-0.01%Si

Microstructure Refinement Mechanism of Undercooled Cu55Ni45 Alloys

Theoretical Investigation of Cu Influence on the Stability Characteristics of T-phase in Crossover Alloys

The microstructures and mechanical properties of a highly alloyed Al-Zn-Mg-Cu alloy: The role of Cu concentration

Role of Cu on the Mechanical Properties and Microstructures Evolution of Al-xCu-1Li-0.4Mg–1Zn-0.1Zr Alloys

Investigation on the microstructural evolution and corrosion behaviors of Zn-microalloyed Al-Cu-Li alloys

First-principles calculation of the effects of In doping on η-Cu 6 Sn 5 structure, elastic anisotropy, electronic properties and fracture toughness

Correlations among stress corrosion cracking, grain-boundary microchemistry, and Zn content in high Zn-containing Al–Zn–Mg–Cu alloys

Effects of Cu on the high-entropy alloys of Cu x CoCrFeNi: Experiment and molecular dynamics simulations

Effect of Cu and Mn content on solidification microstructure, T-phase formation and mechanical property of Al Cu Mn alloys

Mechanical and electrochemical characterization of CuAlNi alloys

Correlation between structures and atomic transport properties of compound forming liquid Cu-In alloys

Experimental investigation of wetting characteristics in Cu-In alloy