Abstract:Highly nanotwinned (NT) metals have advantages such as high strength, good ductility, favorable corrosion resistance, and thermal stability. It has been demonstrated that the introduction of high density NT microstructures can enhance the tribological properties of metals. However, the influence of the microstructure and the composition of NT alloys on the tribological behavior are not clear. In this work, the sliding wear behavior of fully NT materials, specifically Cu-Al and Cu-Ni alloys, are studied by a nanoscratch technique using a nanoindenter. The effects of microstructure and chemical composition on the wear properties are also studied. The results show that the chemical composition has an obvious influence on the wear resistance and microstructural deformation. For NT Cu-Al alloys, the hardness and sliding wear resistance improve with increased Al content from Cu-2wt.%Al to Cu-6wt.%Al. NT Cu-10wt.%Ni alloy shows even better wear resistance than Cu-6wt.%Al. The microstructural analysis shows that NT Cu alloys with higher wear resistance correspond to a smaller deformation-affected zone. The improvement of sliding wear properties of Cu-Al alloys with higher Al content may be ascribed to their decreased stacking fault energy. NT Cu-Ni alloy shows better wear resistance than Cu-Al alloy, this may be related to the formation of intermetallic compounds in Cu-Al system. This study broadens the knowledge about tribological properties of NT materials and provides a potential method to optimize their sliding wear resistance by altering the chemical composition of NT Cu alloys.

Mechanical and electrochemical characterization of CuAlNi alloys

The Effect of Al on Microstructure and Properties of Cu-15Ni-8Sn During the Aging

Effects of Cu Addition on the Microstructure and Properties of the Al–Mn–Fe–Si Alloy

Effects of Cu on the high-entropy alloys of Cu x CoCrFeNi: Experiment and molecular dynamics simulations

Effect of Al Element on the Microstructure and Properties of Cu-Ni-Fe-Mn Alloys

Microstructure and Mechanical Properties of Cu–12Al–xNi Alloy Prepared Using Powder Metallurgy

Multi-component Phase-Field Simulation of Microstructural Evolution and Elemental Distribution in Fe–Cu–Mn–Ni–Al Alloy

Mechanical Properties and Oxidation Characteristics of TiNiAl(Nb) Intermetallics

Effect of Cu on Nanoscale Precipitation Evolution and Mechanical Properties of a Fe-NiAl Alloy.

Enhanced mechanical and damping properties of Cu-Modified Al-Ni eutectic alloys: Solid-solution and precipitation hardening effects

On the Evolution of Nano-Structures at the Al–Cu Interface and the Influence of Annealing Temperature on the Interfacial Strength

High-throughput experimental study on the microstructural and compositional variations of mechanical properties for AlCoCrFeNi high entropy alloys

Effects of co-addition of Ni and Al on precipitation evolution and mechanical properties of Fe-Cu alloy

Sliding Wear Behavior of Fully Nanotwinned Cu Alloys

Investigation of Microstructure and Wear Properties of Precipitates-Strengthened Cu-Ni-Si-Fe Alloy.

Molecular Dynamics Studies of The Effects of Copper on The Mechanical Properties of Aluminum

Theoretical investigation of energetics and mechanical properties of intermetallics in copper clad aluminum composite

Numerical investigation of mechanical properties of aluminum-copper alloys at nanoscale

Effect of Ni addition on the microstructure, conductivities and mechanical properties of as-cast Al-Fe alloys

First-Principles Calculations of Structural and Mechanical Properties of Cu–Ni Alloys

Micro-alloying effects of Ni on the microstructure and mechanical properties of an Al-Zn-Mg-Cu-Sc-Zr alloy