Abstract:In this investigation, a novel heat-sensitive material titanium oxide (TiOx) thin film was deposited on well cleaned K9 glass substrates by d.c. reactive magnetron sputtering from a metallic titanium target in an Ar + O2 gas mixture. In order to obtain proper TiOx thin films, deposition parameters should be properly controlled. In our system, TiOx thin films were obtained at different substrate temperature while total pressure and oxygen partial pressure were kept at 1 Pa and 0.6 Pa, d.c. power of 100 W, and the deposition time was adjusted in order to deposit thin films with a constant thickness close to 200 nm. The crystalline structure was characterized by X-ray diffraction (XRD) analysis and the results show that all the deposited films have an amorphous structure. In this paper, we have mainly investigated the dependence of electrical and optical properties of the reactively sputtered TiOx thin films on the different substrate temperature during the sputtering process, i.e., as the K9 glass substrate temperature increases from 100 °C to 250°C, the sheet resistance Rs of TiOx thin films is ranged from 305 kΩ/square to 36 kΩ/square, temperature coefficient of resistance (TCR) value up to -2.12 %/K is obtained, optical band gap decreases from 3.34 eV to 3.28 eV. Through the analysis and discussion of the above experimental data, we could obtain the conclusion that the variation in substrate temperature during the sputtering deposition plays a considerable important role in the electrical and optical properties of all the deposited films.

Effect of Substrate Materials on Rutile Crystalline Orientation in Plasma-Sprayed Tio2 Coatings

The Microstructure of Al2O3/TiO2-NiCrBSi Graded Thermal Barrier Coatings Produced by Flame Spraying

Origin of Preferential Orientation of Rutile Phase in Thermally Sprayed Tio2 Coatings

Valence Electron Structure Analysis of Crystalline Orientation in Plasma-Sprayed Tio2 Coatings

TiO2 films prepared by DC reactive magnetron sputtering at room temperature: Phase control and photocatalytic properties

Crystallization Behaviors of TiO2 Films Derived from Thermal Oxidation of Evaporated and Sputtered Titanium Films

Phase Formation During Deposition of Tio2 Coatings Through High Velocity Oxy-Fuel Spraying

The Crystallization Mechanism of Reactive Plasma Spraying

Investigation of microstructure evolution in Pt-doped TiO2 thin films deposited by rf magnetron sputtering

Effect of the Substrate Temperature on the Crystallization of TiO2 Films Prepared by DC Reactive Magnetron Sputtering

Influence of Substrate on Structural, Morphological and Optical Properties of TiO2 Thin Films Deposited by Reaction Magnetron Sputtering

Investigation on the Performance of TiN Coatings by Reactive Plasma Spraying Crystallization

Photocatalytic performance and microstructure of thermal-sprayed nanostructured TiO2 coatings

Influence of Different Substrates on MgTiO_3-CaTiO_3 Thin Films Prepared by RF Sputtering

Synthesis, Phase Transition and Optical Properties of Nanocrystalline Titanium Dioxide Films Deposited by Plasma Assisted Reactive Pulsed Laser Deposition

Influence of Plasma Spraying Parameter on Microstructure and Photocatalytic Properties of Nanostructured TiO2–Fe3O4 Coating

Dominant microstructural feature over photocatalytic activity of high velocity oxy-fuel sprayed TiO2 coating

The Influence of Substrate Temperature on the Electrical and Optical Properties of Titanium Oxide Thin Films Prepared by D.c. Reactive Magnetron Sputtering

Hetero-Orientation Epitaxial Growth of TiO 2 Splats on Polycrystalline TiO 2 Substrate

Tunable thermo-optical performance promoted by temperature selective sputtering of titanium oxide on MgO-ZrO2 coating

Effect of Substrate Surface Roughness on Microstructure and Mechanical Properties of Cold-Sprayed Ti6Al4V Coatings on Ti6Al4V Substrates