Abstract:This paper presents a three-dimensional modeling approach for the curing process of polymer-matrix composites (PMCs). The presented model could fully characterize the heat transfer, exothermic reactions in resin crosslinking, material time-varying properties, resin flow, and fiber compaction during the curing process. The predicted non-uniform distribution of thickness of the L-shaped composite laminate samples coincides well with experimental results. It is observed that the three-dimensional model, compared to the two-dimensional model, better captures the solidification in complex structural regions, such as the R-corner and the thickness variation region. By comparing the residual stress, fiber volume fraction, and non-uniform thickness of the laminate samples with different layup orientations, the experimental and computational results both show that the corner region of [90] 20 laminate is thinner than other regions, with a higher fiber volume fraction. This is attributed to the mismatch of reactive stresses between the tool side and bag side, primarily compressive radial stress. In contrast, the corner region of the [0] 20 laminate is thicker than other regions, with a lower fiber volume fraction. This difference is mainly due to the mismatch of radial stresses, hindrance caused by compressive hoop stresses in the compaction process, and potential wrinkling of hoop fibers due to interlaminar shear constraints.

Theory deposition model and influencing factors during process of preparing micro-layer laminate by EBPVD

Characterization of EBPVD Micro-Layer Composites and Simulation of Its Internal Stress State

Numerical Simulation of Residual Stress During Microlayer Composite Material Processing by Ebpvd Technique

FEM analysis of stress distribution in metal/ceramic multi-layer composites prepared by EBPVD technique

Modeling Of Two-Dimensional Dynamic Temperature Distribution Of A Lpcvd Process And Control Design By Mpc

Modeling and experimental validation of compaction pressure distribution for automated fiber placement

Thermal Management for Thermoset Automated Fiber Placement Based on Infrared Heater Structure Arrangement

Finite element modeling of residual stress of Ti/TiAl multilayer composites prepared by electron beam physical vapor deposition technology

The effects of substrate temperature on the residual stress for EBPVD

The Effects of Substrate Temperature on the Residual Stress for EBPVD TBCs

Research on Preparing Microlaminated Materials by Technology of EB-PVD

Influence of Process Parameters on the Interlaminar Shear Strength of CF/PEEK Composites In-Situ Consolidated by Laser-Assisted Automated Fiber Placement

Investigation on layer variation behavior and process stability during direct laser deposition using a semi-theoretic analysis model

Preparation and Microstructure Analysis of Ti-Al Sheet by Electron Beam Physical Vapor Deposition

Effect of processing parameter on Ti-Al thin sheet deposited by EB-PVD technology

The Influence of Deposition Process on Polymer Conformation in Langmuir-Blodgett-Films

Thickness Distribution Model of Condensate on Rotary Substrate by EB-PVD

Microstructure Dependence of Effective Thermal Conductivity of EB-PVD TBCs

Ni/Ni3Al microlaminate composite produced by EB-PVD and the mechanical properties

A 3D modeling of the effect of layup orientation on the thickness uniformity of cured composite L-shaped laminates

Thickness Distribution of Large Scale Metallic Sheet by Eb-Pvd on Rotating Substrate