Abstract:The intake duct is an important component of waterjet propulsion system and its hydraulic performance is directly connected with the capability of the waterjet pump and even the propulsion performance of the system. In order to optimize the flush-type intake duct, the present paper proposes a multi-objective optimization system including Design of Experiments (DOE), Computational Fluid Dynamics (CFD), three-dimensional parametric design, approximate model, the modified Non-dominated Sorting Genetic Algorithm-II (NSGA-II) and a Technique for Ordering Preferences by Similarity to Ideal Solution (TOPSIS). The nonuniformity and perpendicularity of outflow, and hydraulic efficiency for the intake duct are treated as the optimization objectives with four geometrical parameters as the design variables. Local sensitivity analyses indicate that the optimization objectives are significantly affected by the inclination angle and slightly affected by the lip vertical distance of the intake duct. During IVR = 0.3-0.8, the outflow quality and hydraulic efficiency of the optimised intake duct are greatly improved. The nonuniformity after optimization decreases by 27.8% and perpendicularity increases by 3.07% at the design condition of IVR = 0.7 and V-s = 19.49 m/s. Based on the flow at the outlet plane of intake duct, the pressure distribution after optimization is very uniform and the tangential velocity is small without obvious secondary flow. During the application to a mixed-flow waterjet propulsion system at various navigation speeds, the nonuniformity of the optimized intake duct decreases by 20.4% and perpendicularity increases by 4.11% on average, demonstrating that the optimized intake duct performs a better outflow quality. It is also noted that the non-uniform flow from the intake duct mainly affects pressure distribution on the suction surface of impeller blade and causes different shaft power.

System Capability Estimating for a Metal/water Reaction Fuel Ramjet System

A Thrust Test Method for Water Ramjet Engine

Conceptual Design and Optimization of Scramjet Engines Using the Exergy Method

Design Method of Water Jet Pump Towards High Cavitation Performances

Design of Contra-Rotating Waterjet Pump Based on High Cavitation Performances

Design and analysis of rocket engine system with electric pump as subsystem

The Research on High-Speed Gas Jet of Rocket Nozzle Underwater

Parametric study on mixing augmentation mechanism induced by cantilevered ramp injectors in a shock-induced combustion ramjet engine

Concept and Key Technology Analysis of Electric Pump-Fed Liquid Propellant Rocket Engine

Research on Virtual Prototype and Digital Test Method of Pump-Fed Propulsion System

Numerical simulation of reacting flow and fuel regression rate in N 2O/htpb hybrid rocket motor

Improvement of Mixing Efficiency in the Combustion Chamber of a Powder-Fuel Ramjet Engine

Optimization of Flight Stability of Water Rockets by Integrated Analysis of "Dynamic Simulation System" and "Robust Design"

Ejector mode performance improvement of rocket-based combined cycle engine designed for dual-ramjet mode

Ballistic Penetration Test and Simulation of Metallic Aircraft Wing Fuel Tank

Multi-objective Optimization of the Flush-Type Intake Duct for a Waterjet Propulsion System

Numerical Investigation on the Effect of Fuel-Rich Degree in the RBCC Engine under the Ejector Mode

Investigation of RBCC performance improvements based on a variable geometry ramjet combustor

Multifactor response-based optimization for enhancing cavitation performance of short injection self-priming pumps

The Auto-docking and Auto-separating Mechanism Designed for the Rocket Fuel Loading

Optimisation strategy to enhance the performance and efficiency of self-rotary water-jet derusting sprayers