Abstract:<p>Liquid monopropellant rocket engines are widely used in space propulsion and are developing in the direction of non-toxic and pollution-free propellants. The use of non-toxic monopropellants with a low decomposition rate makes the start-up and shutdown processes of the engines longer, and the gas inlet assumptions that were applicable to the calculation of hydrazine monopropellant engines cannot be used. Based on the steady-state calculation model of hydroxyl ammonium nitrate (HAN)-based monopropellant engine, we propose a combined model that considers decomposition of liquid monopropellant and non-equilibrium heat transfer between fluid and solid catalyst bed, and uses this model and the gas inlet hypothesis to calculate the working process of an HAN-based monopropellant rocket engine of 60 N thrust. The calculated results are compared with the test curve, and the results show that the decomposition of liquid monopropellant plays a key role in the starting and stopping processes. When the gas inlet assumption is adopted without considering the decomposition of the liquid monopropellant, the calculated start-up time is much shorter than the hot-firing test, and there is no tail-off section when shutting down. The pressure-rise and pressure-decay curve calculated by the combined model agree well with the test curve, and the maximum deviation during the steady state is less than 10%. For HAN-based monopropellant engines, the pressure rises slowly at the first start because the temperature of catalyst bed is lower, which results in a lower rate of decomposition. When restarted shortly after a shutdown, the pressure rises rapidly due to the high temperature of the catalyst bed and the high rate of decomposition. The HAN-based monopropellant can penetrate a few millimeters downstream of the injector, and there is a significant tail when the engine is shut down, which is caused by the continued decomposition of the remaining propellant after the shutdown.</p>

Numerical simulation of reacting flow and fuel regression rate in N 2O/htpb hybrid rocket motor

Numerical Calculation on Behavior of Fuel Regression in Hybrid Rocket Motor

Combustion performance and scale effect from N 2 O/HTPB hybrid rocket motor simulations

Long-Duration Dynamic Numerical Simulation of Combustion and Flow in Hybrid Rocket Motors Considering Nozzle Erosion

Prediction of the fuel regression-rate in a HDPE single port hybrid rocket fed by liquid nitrous oxide

Numerical investigation on regression rate and thrust regulation behaviors of a combined solid rocket motor with aluminum-based fuel

THE NUMERCAL SIMULATION OF REACTING VISCOUS FLOW IN 2D ROCKET MOTOR COMBUSTOR

Regression rate and combustion performance investigation on hybrid rocket motor with head-end swirl injection under high geometric swirl number

Numerical Simulation Coupling on Fluid Flow and Heat Transfer in Nozzle and Equipment Cabin of Solid Rocket Motor during Operation Process

Experimental Investigation of N2O-PMMA Lab-Scale Hybrid Rocket Motor

Pseudo-Two-Dimensional Modeling and Validation of a Hybrid Rocket Combustion Chamber

Phenomenological regression rate model in axial injection end-burning hybrid rocket motor using different oxidizers

Dynamic Numerical Simulation of Hybrid Rocket Motor with HTPB-Based Fuel with 58% Aluminum Additives

Similarity solution of fuel mass transfer, port mass flux coupling in hybrid propulsion

Numerical simulation of the transient process of monopropellant rocket engines

Numerical Simulation of Wall Liquid Film in Small Bipropellant Rocket Engine

The Numerical Simulation and Experimental Validation of Viscous Flow Field of Chemical Reaction in 2D Rocket Motor Combustor

Numerical Simulation of Inner Flow Field of a Pintle Injector Variable Thrust Rocket Engine

Modeling of Spray Combustion and Heat Transfer of MMH/N2O4 in a Small Rocket Engine Using Different Mechanisms

Regression rate of paraffin-based fuels in hybrid rocket motor

Numerical Simulation and Experimental Validation of Chemical Reaction Viscous Turbulent Flow Field in the Nozzle of Liquid Rocket Motor