Abstract:<p>Liquid monopropellant rocket engines are widely used in space propulsion and are developing in the direction of non-toxic and pollution-free propellants. The use of non-toxic monopropellants with a low decomposition rate makes the start-up and shutdown processes of the engines longer, and the gas inlet assumptions that were applicable to the calculation of hydrazine monopropellant engines cannot be used. Based on the steady-state calculation model of hydroxyl ammonium nitrate (HAN)-based monopropellant engine, we propose a combined model that considers decomposition of liquid monopropellant and non-equilibrium heat transfer between fluid and solid catalyst bed, and uses this model and the gas inlet hypothesis to calculate the working process of an HAN-based monopropellant rocket engine of 60 N thrust. The calculated results are compared with the test curve, and the results show that the decomposition of liquid monopropellant plays a key role in the starting and stopping processes. When the gas inlet assumption is adopted without considering the decomposition of the liquid monopropellant, the calculated start-up time is much shorter than the hot-firing test, and there is no tail-off section when shutting down. The pressure-rise and pressure-decay curve calculated by the combined model agree well with the test curve, and the maximum deviation during the steady state is less than 10%. For HAN-based monopropellant engines, the pressure rises slowly at the first start because the temperature of catalyst bed is lower, which results in a lower rate of decomposition. When restarted shortly after a shutdown, the pressure rises rapidly due to the high temperature of the catalyst bed and the high rate of decomposition. The HAN-based monopropellant can penetrate a few millimeters downstream of the injector, and there is a significant tail when the engine is shut down, which is caused by the continued decomposition of the remaining propellant after the shutdown.</p>

Prediction of the fuel regression-rate in a HDPE single port hybrid rocket fed by liquid nitrous oxide

Numerical simulation of reacting flow and fuel regression rate in N 2O/htpb hybrid rocket motor

Phenomenological regression rate model in axial injection end-burning hybrid rocket motor using different oxidizers

Experimental Investigation of a Swirling-Oxidizer-Flow-Type Hybrid Rocket Engine Using Low-Melting-Point Thermoplastic Fuel and Oxygen

Regression Rate and Performance Analysis via Ballistic Reconstruction of a small-scale H 2 O 2 -based Hybrid Rocket fuelled by Polyvinyl Chloride

Regression rate of paraffin-based fuels in hybrid rocket motor

Combustion performance and scale effect from N 2 O/HTPB hybrid rocket motor simulations

Regression rate modeling of HTPB/paraffin fuels in hybrid rocket motor

Pseudo-Two-Dimensional Modeling and Validation of a Hybrid Rocket Combustion Chamber

Numerical Calculation on Behavior of Fuel Regression in Hybrid Rocket Motor

Computational Analysis and Regression Laws for Nozzle Erosion Prediction in Hybrid Rockets

Long-Duration Dynamic Numerical Simulation of Combustion and Flow in Hybrid Rocket Motors Considering Nozzle Erosion

Dynamic Numerical Simulation of Hybrid Rocket Motor with HTPB-Based Fuel with 58% Aluminum Additives

Multiphysics Modeling for Combustion Instability in Paraffin-Fueled Hybrid Rocket Engines

Numerical Analysis of Temperature Rise Within 70 MPa Composite Hydrogen Vehicle Cylinder During Fast Refueling

Impact of chemical modeling on the numerical analysis of a LOx/GCH4 rocket engine pintle injector

Study of a hybrid gas generator for a ducted rocket

Regression Rate and Combustion Efficiency of Composite Hybrid Rocket Grains Based on Modular Fuel Units

Modeling of Spray Combustion and Heat Transfer of MMH/N2O4 in a Small Rocket Engine Using Different Mechanisms

Numerical simulation of the transient process of monopropellant rocket engines

Numerical investigation of high-pressure combustion in rocket engines using Flamelet/Progress-variable models