Abstract:In this paper, the fretting wear behaviour of steel wires working in coal mining technology is studied numerically. In past studies, the fretting process of steel wires was carried out numerically considering that the coefficient of friction (COF) and wear coefficient (WC) are constant parameters. However, it has been noticed experimentally that COF increases up to a certain number of fretting cycles and then becomes constant, i.e. a steady-state stage, depending on the loading conditions. This increase in COF during the fretting process is also known as the running-up stage. The fretting wear model is modified to evaluate the influence of the varying coefficient of friction (VCOF), which is associated with the variable wear coefficient (VWC), so the influence of VWC is also considered. The subroutine UMESHMOTION used to implement the wear law is also modified to study the effect of VCOF and VWC. Therefore, in this study, the numerical results of a three-dimensional finite element (FE) model are compared, with analytical results of contact area and contact stresses, and with experimental results of peak wear depth. After validating the FE model, the wear scar, the increasing wear depth, wear volume, and the decreasing contact stress with increasing fretting cycles are determined numerically considering VCOF and VWC using cycle jump approach. The energy dissipation effect of frictional force and fretting amplitude is also studied for varying interaction properties of fretting wear models. The numerical simulations are performed by considering both elastic and plastic material properties to analyse the influence of varying interaction properties on fretting wear models at the running-up stage. The results indicate that the VWC model exhibits comparable impacts on both the elastic and plastic models. The results also show that the VWC fretting wear model leads to higher wear scar, wear volume, and wear depth values at the running-up stage as well as at the steady state stage, which are close to the experimental data.

3D Dynamic Simulation of Groove and Ridge in Two-Body Abrasive Wear by Finite Element Method

Numerical Investigation of the Evolution of Grit Fracture and Its Impact on Cutting Performance in Single Grit Grinding

Finite Element Simulation and Analysis of Aluminum Alloy Three-Dimensional Milling

Contact Analysis of Abrasive Wear

A study of the mechanisms of abrasive wear for ductile metals under wet and dry three-body conditions

Finite element analysis of fretting wear considering variable coefficient of friction

A Debris Layer Evolution-Based Model for Predicting Both Fretting Wear and Fretting Fatigue Lifetime

Frictional Study on 30CrNi2MoVA Steel Based on Experiments and Finite Element Simulation: Wear Prediction

Study on Simulation of Coupled Heat Transfer, Stress and Wear Behavior in Pin-on-disc Experiments

An explicit finite element approach for simulations of transient meshing contact of gear pairs and the resulting wear

A Coupled Finite Element and Meshfree Analysis of Erosive Wear

Finite element analysis of sliding wear on the borided AISI 316L stainless steel

A computationally efficient method for the prediction of fretting wear in practical engineering applications

Modeling adhesive and abrasive wear phenomena in fretting interfaces: A multiphysics approach coupling friction energy, third body and contact oxygenation concepts

Coupling fractal model for adhesive and three-body abrasive wear of AISI 1045 carbon steel spool valves

Effect of groove textures on wear of friction pair between groove side and scraper under different factor combinations

Wear simulation of UHMWPE against the different counterface roughness in reciprocating unidirectional sliding motion

Analytical modeling of particle size effect on impact wear deformation characteristics of ductile materials

Finite Element Model of Erosive Wear on Ductile and Brittle Materials

Simulation of fretting wear in steel wires under variable coefficient of friction and variable wear coefficient

Experimental and Numerical Simulation Study on Erosion Wear Behavior of AISI 1020 Steel