Abstract:Laser surface texturing is considered as a novelty and feasible technology to fabricate some micro-feature due to the non-contact, high precision and processing efficiency. However, it is difficult to deeply understand the material removal mechanism and predict the surface topography due to a confined heat-affected zone and extremely short time in the laser machining process. In this research, based on the mixed phase theory and level-set method, a modified heat-mass transfer and hydrodynamic model was proposed for deeply analyzing the influence of various physical factors such as recoil pressure, buoyancy, surface tension, gravity and thermal-mass transport on the material removal and micro-texture topography evolution at a mesoscale level. The analysis of hydrodynamic behaviors and temperature fields of the molten pool indicated that the melts sputtering and molten pool expansion caused by the recoil pressure was the dominant factor responsible for micro-texture formation during laser action. The reflux induced by the surface tension and gravity as well as the residual effect of the melts flowing upward were the main factors of the occurrence of a vortex during the molten pool cooling. Finally, the effects of laser parameters on the micro-feature topography were discussed based on the experiments and simulation model. The diameter and depth of the hole as well as the width and depth of the groove gradually increased with increasing frequency and pulse duration. The laser moving speed had less effect on the width of the groove, but it had great effect on the surface roughness of the groove. This work can be beneficial to understand the material removal mechanism and provide a guide for the parameters optimization of laser processing at a mesoscale level.

The experimental research of new topography applicable to texture of cold roller by laser

Investigations in the fabrication of surface patterns for wettability modification on a Zr-based bulk metallic glass by nanosecond laser surface texturing

Design Research on Roller of New Fiber Carding Machine

Laser Texturing of Rolled Surfaces

Laser texturing of rollers by pulsed Nd:YAG laser

Theoretical and numerical investigation of micro-textures fabrication by ultrasonic surface rolling process

Laser Dulling for Roll Surface by Pulsed Nd:YAG Laser

An Analysis of the Three-Dimensional Surface Topography of Textured Cold-Rolled Steel Sheets

A Study on Surface Topography in Cavitation Erosion Tests of AlSi10Mg

Hybrid Analytical-Numerical Solution Model for Laser Surface Processing and Its Application in Texturing of Roll Surface

Influence of the rotational speed ratio of rollers on the three-dimensional surface rolling process

Effect of Surface Roughness of Steel on Morphology of Laser-textured Micro-convex

Texturing skin-pass rolls by high-speed laser melt injection, laser ablation, and electrolytic etching

Effect of laser shock peening on the retention ability of surface roughness in forged Cr5 steel

Investigation of Micro-wear and Micro-friction properties for bionic non-smooth concave components

Surface Texturing with Laser Multiple-Spot Scanning Technology

Tribological Behavior of Laser Textured Hot Stamping Dies

Research in Improving Tribology Performance by Surface Texturing

Laser micro-texture formation mechanism based on modified heat-mass transfers and hydrodynamic models

Fabrication of Interference Textures on Cemented Carbides Using Nanosecond and Femtosecond Laser Pulses

Surface Modification of Roll by Pulsed ND:YAG Laser: Bump Formation Caused by Martensitic Transformation