Abstract:On the basis of previous experimental studies of two-phase flow condensation heat transfer for R134a inside the horizontal micro-fin tubes, a theoretically analysis of heat transfer characteristic combining both heat transfer mechanism and flow mechanism is discussed by the experimental data of heat transfer coefficient and pressure drop, to further clarify the influence of experimental condition and tube structure on heat transfer characteristics under the special working condition. Two performance factors, enhancement factor (EF) and penalty factor (PF), are introduced to quantitatively compare the effect of micro-fin on the heat transfer coefficient and the pressure drop between enhance tube and smooth tube. Meanwhile, the comprehensive factor, CHF, is applied to evaluate the comprehensive performance of heat transfer tube. It was found that enhancement factor (EF) and penalty factor (PF) both increase with increasing mass flux and fin helical angle, and decreasing saturation temperature, the comprehensive factor, CHF, is always greater than one and increases with increasing fin helical angle and mass flux, and decreasing saturation temperature. Moreover, based on the comparative analysis findings that some existing correlations of heat transfer characteristics underestimate most of the experimental data, and the experimental variable has great influences on the correlation prediction accuracy, such as mass flux, which is proportionate to the prediction deviation of correlation. Therefore, a new correlation was developed through analyzing quantitatively influencing mechanism of the experimental variable on the heat transfer characteristics, in a way that a two-phase frictional multiplier is defined firstly from the experimental data and then the forced convection heat transfer mechanism is redefined based on the comprehensive effect of various experimental variables. By the experimental data verification, the new correlation shows good prediction effect with the mean deviation of less than 5%.

Study on the Heat Transfer Enhancement of Two-Phase Flow Elevation Tube in LiBr Chiller with Hot Water Source

Study of the Natural Circulation Flow Boiling Heat Transfer Based On Partially Superhydrophilic Surface Modification

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Experimental Study on an Thermosyphon Loop with Bubble Pump Effect

Heat transfer enhancement of helical tubes during pool boiling

Comparison of flow boiling heat transfer characteristics inside different enhanced heat transfer tubes

An Experimental Study Of Thermal Performance Of A Two-Phase Loop Thermosyphon (Tplt)-Based Steam Generator: Effects Of Thermal Boundary Conditions

Experimental Investigation of Flow Boiling Inside Three Three-Dimensional Surface Enhanced Heat Transfer Tubes

Experimental study on the effect of filling ratio on an R141b two-phase thermosyphon loop with a horizontal parallel tube evaporator

Boiling curve of subcooled flow boiling of DI water from forced convection region until reaching CHF under different operation parameters in a vertical tube

Internal Flow Boiling Heat Transfer Enhanced in Vertical Tubes with Longitudinal Microchannels

Experimental investigation of two-phase flow characteristics of LiBr/H 2O solution through orifice plates in vacuum environment

Flow Boiling in Inner Annulus of Horizontal Enhanced Tubes

Eexperimental Study On Flow Evaporation Heat Transfer Characteristics Inside Horizontal Three-Dimensional Enhanced Tubes

Experimental Study Of Condensation Flow Inside Horizontal Smooth, Herringbone And Three Enhanced Surface Tubes

EXPERIMENTAL STUDY ON HEAT FLUX EFFECT ON EVAPORATION IN TWO DIMPLE-GROOVED TUBES

Two-phase Heat Transfer Correlations in Three-Dimensional Hierarchical Tube

Local Heat Transfer of Saturated Flow Boiling in Vertical Narrow Microchannel

Experimental Study on Condensation and Evaporation Flow Inside Horizontal Three Dimensional Enhanced Tubes

Experimental Study of Heat Transfer Enhancement for Molten Salt with Transversely Grooved Tube Heat Exchanger in Laminar-Transition-turbulent Regimes

Experimental investigation of two-phase heat transfer in saw-tooth copper microchannels