Abstract:International Journal of Modern Physics B, Ahead of Print. A simple approach dealing with thermal oxidation at atmospheric pressure was used to synthesize copper oxide nanowires (CuO-NWs) on copper substrate. The vertically oriented CuO-NWs were used for further subjected to deposition of ultrathin layer (∼20[math]nm) of lanthanum hexaboride (LaB[math] using the electron beam evaporation technique. The observation of the characteristic vibrational mode of LaB6 in the Raman spectrum of LaB6-coated CuO-NWs (LaB6@CuO-NWs) revealed the existence of LaB6 in the deposited sample. Furthermore, confirmation of LaB6 coating on CuO-NWs was corroborated by X-ray photoelectron spectroscopy (XPS) analysis. The field electron emission (FEE) characteristics of pristine CuO-NWs and LaB6@CuO-NWs were investigated in a planer diode geometry at a base pressure of [math][math]mbar. The values of turn-on and threshold fields (defined at emission current density of 1 and 10[math][math]A/cm2, respectively) were found to be 5.4[math]V/[math]m and 1.6[math]V/[math]m (for pristine CuO-NWs emitter) and 6.75, and 2.85[math]V/[math]m (for LaB6@CuO-NWs emitter). Interestingly, a noticeably large emission current density of [math][math][math]A/cm2 has been extracted from the LaB6@CuO-NWs emitter at a relatively lower applied field of 5.8[math]V/[math]m. The Fowler–Nordheim (FN) plots of both the emitters showed nonlinear behavior, indicative of their semiconductive nature. Furthermore, both the emitters showed relatively stable emission behavior tested at a pre-set value of 1[math][math]A more than 3[math]h. The enhanced FEE behavior of LaB6@CuO-NWs emitter is attributed to the modulation of electronic properties due to LaB6-CuO interface-induced effects. Although the promising FEE behavior of LaB6@CuO-NWs emitter warrants its potential for practical applications, further improvement can be achieved via fabricating an array emitter due to CuO NWS and optimizing the thickness of LaB6 coating.

Study On Preparation And Thermionic Emission Of Nanometer Rare-Earth Tungsten Emission Materials

Field-Emission Properties of Nanostructured Wo3 Arrays Fabricated Using Tungsten Hot-Filament Chemical Vapor Deposition

Thermionic Energy Conversion with Nanoscale Materials and Devices

Fabrication of Lanthanum Hexaboride Single Nanowire Field Emitter and Their Field Emission Properties

Surface Properties of Rare-Earth Metals and the Effects of Their Substitutional Doping on Work Function of the W(110) Surface

LaB6 Nanowires and Their Field Emission Properties

Effect Of Surface O-2 Adsorption On The Field Emission Performances Of Lab6 Nanowires

Improved field electron emission behavior of ultrathin lanthanum hexaboride-coated copper oxide nanowires

Nanomaterials for Field Electron Emission: Preparation, Characterization and Application.

Effect of Surface O2 Adsorption on the Field Emission Performances of LaB6 Nanowires

Easy Growth of Large-Area Tungsten Oxide Nanostructures and Their Field Emission Properties

Preparation Process and Luminescence Properties of Rare Earth Doped Double Tungstates Nanocrystals

Study on Emission Properties of the Nanopatical Films

Field Emission Microscopy Study of Zinc Oxide Nanowires on Tungsten Tip

Hydrothermal Synthesis and Luminescence Behavior of Rare-Earth-doped NaLa(WO4)2 Powders

In-situ Field Emission Studies of Individual One-Dimensional Nanostructures Based on Scanning Electron Microscope

Work function and surface stability of tungsten-based thermionic electron emission cathodes

Amazing Ageing Property and in Situ Comparative Study of Field Emission from Tungsten Oxide Nanowires

A Low-Temperature Method to Selected-Area Synthesis of Tungsten Oxide Nanowire Arrays and Investigation on Their Field Emission Properties

Tunable field emission characteristics of ZnO nanowires coated with varied thickness of lanthanum boride thin films

A moderate synthesis route of 5.6 mA-current LaB6 nanowire film with recoverable emission performance towards cold cathode electron source applications