Abstract:Autothermal reforming (ATR) of methane is a promising technology for low-carbon H2 production due to its high CO2 capture efficiency (>95 %) and cost advantage. Especially, reforming CO2+CH4 greenhouse gases to valuable CO+H2 gases is a feasible solution for carbon-neutral energy systems. Flame temperature, reforming gas composition and concentration, and soot loading are major factors determining the efficiency of H2 production in the subsequent catalyst region. In this study, the effects of CO2/CH4 ratio on the profiles of temperature, OH radical, light gas products, large polycyclic aromatic hydrocarbons (PAHs), and soot were investigated for CH4-CO2-O2 laminar inverse diffusion flames near ATR conditions, using the combined non-intrusive and intrusive diagnostic methods. Pure O2 as oxidizer was fed through the central nozzle of the burner surrounded by CH4 fuel diluted with CO2. The experimental results revealed that the formation of soot and PAHs was greatly suppressed with a higher CO2/CH4 ratio. The PAHs and soot loading followed exponential function as CO2/CH4 mole ratio, regardless of pressure, O2 mole fraction, and burner size. The flame height was found to increase linearly with CO2 dilution, and the high temperature region (> 1000 K) shifts downstream. The H2 production decreased with CO2/CH4 ratio, while CO production is less sensitive to CO2 dilution. The importance of radical species during soot formation is confirmed based on the comprehensive data set. Moreover, five well-known chemical-kinetic mechanisms were evaluated against experimental datasets. The comparisons indicate that the flame temperature and concentration trends of investigated species are well predicted, but future work is needed to improve the prediction accuracy of amplitude and spatial distribution, especially for C2H2, PAHs and soot. The reported experiment and simulation results can provide valuable guidance for ATR model validation, development, reduction, and application.

Modeling and Performance Analysis of Gas Auto-Thermal Reformer

Modeling and Simulation of Commercial Catalytic Reformers

Modeling, Simulation and Optimization of a Whole Industrial Catalytic Naphtha Reforming Process on Aspen Plus Platform

A dynamic model for naphtha catalytic reformers

Simulation, sensitivity analysis and optimization of a continuous catalytic reforming process

Exergy analysis and CO2 emission evaluation for steam methane reforming

Characterization of CH4-CO2-O2 Diffusion Flames Near Autothermal Reforming Condition

Two-section reactor model for autothermal reforming of methane to synthesis gas

Simulation of Natural Gas Steam Reforming Furnace

Thermodynamic Analysis of Performance of Steam Methane Reforming Hydrogen Production System Connected with High-Temperature Gas-Cooled Reactor

Fuel Adaptability Study of a Lab-Scale 2.5 Kwth Autothermal Reformer

Numerical Analysis of Steam Reformer of Steam Methane Reforming Hydrogen Production System Connected with High Temperature Gas Cooled Reactor

Cold Model Experiment and Simulation of Autothermal Reforming Reactor

PERFORMANCE ANALYSIS FOR NATURAL GAS REFORMING SOFC/MGT HYBRID DISTRIBUTED ENERGY SYSTEM

Hydrogen producing from propane autothermal reforming

Operation Conditions Optimization of Hydrogen Production by Propane Autothermal Reforming for PEMFC Application

Application of One-Dimensional Heat and Mass Transfer Model of Helium Heated Reformer Coupled with HTR-10

Multi-dimensional modeling of non-catalytic partial oxidation of natural gas in a high pressure reformer

An Annular Reactor for Direct Methane Autothermal Reforming

Initial Study on Steam Reformer of High-Temperature Gas-Cooled Reactor Powered Steam Methane Reforming Hydrogen Production System

Performance Simulation of Natural Gas Pre-reforming Solid Oxide Fuel Cell