Abstract:Based on the CFD Fluent software,builds a chevron corrugated plate heat exchanger model,and systematically analyzes the influence of three important parameters of geometry-corrugated angle,corrugated depth,corrugated spacing on the internal temperature field,pressure field,flow field,average Nusselt number and flow resistance on the water-water plate heat exchanger.The results show that the contact points are the best places for heat transfer between two heat exchanger plates and the disturbance of contact points make the strongest turbulences around the contact points,which is the main reason that the fluid turbulence occurs at lower Renault number for the plate heat exchanger and the heat transfer is enhanced.On the other hand,a greater pressure loss occurs after the fluid passes by the contact point,which is the main part of total pressure loss in the plate heat exchanger.Among the three geometric parameters,corrugated angle is the most important one and the best corrugated angle is about 60° with a good heat transfer effect and a moderate flow resistance.The average Nusselt number increases as the corrugated depth increases which enhances the heat transfer with a decreased pressure loss but is apt to scale,thus a corrugated depth of 4~5 mm is appropriate.It is also found that a ratio of the corrugated spacing to the corrugated depth of 3~4 is appropriate at the specified boundary condition.

EFFECT OF HEADER CONFIGURATION ON FLUID FLOW MALDISTRIBUTION IN PLATE-FIN HEAT EXCHANGER

Effect of Header Configuration on Thermal Performance of Plate-Fin Heat Exchangers

Flow Distribution Properties of Header Configuration in Plate-Fin Heat Exchangers

Effect of different improved header on flow and pressuredifference in plate-fin exchangers

Numerical Analysis of Header Structure Improvement in a Plate-Fin Heat Exchanger

EFFECTS OF DIFFERENT DISTRIBUTOR CONFIGURATION PARAMETERS ON FLUID FLOW DISTRIBUTION IN PLATE-FIN HEAT EXCHANGER

Study of flow distribution and its improvement on the header of plate-fin heat exchanger

Investigation of header configuration and its effect on flow maldistribution in plate-fin heat exchanger

NUMERICAL SIMULATION OF HEADER CONSTRUCTION OF PLATE - FIN HEAT EXCHANGER

Fluid Flow Distribution and Heat Transfer in Plate-Fin Heat Exchangers

Numerical study on effect of header’s curve of plate-fin heat exchanger on uniformity of entrance flow field

NUMERICAL STUDY ON FLOW DISTRIBUTION IN PLATE-FIN HEAT EXCHANGERS

Effect of Inlet Flow Maldistribution on the Passage Arrangement Design of Multi-Stream Plate-Fin Heat Exchanger

Experimental investigation of header configuration on two-phase flow distribution in plate-fin heat exchanger

Flow Distributions of Header Configurations in Plate-Fin Heat Exchangers with Particle Image Velocimetry (PIV)

Flow Distribution Performance of Different Distributor's C onfiguration in Plate-Fin Heat Exchanger

Numerical Investigation on Configuration Improvement of A Plate-Fin Heat Exchanger with Perforated Wing-Panel Header

Improvements on Flow Distribution and Heat Transfer Performance of Plate-fin Heat Exchangers by Qusai-S Type Header Configuration

Study on the effect of three key geometric parameters of chevron corrugated brazed plate heat exchanger on the heat transfer performance

Experimental investigation on fluid flow maldistribution in plate-fin heat exchangers

Improvement of entrance configuration in plate-fin heat exchanger