Abstract:Spectroscopic investigations provide important insights into the composition of luminescence emissions relevant to trapped-charge dating of sediments. Accurate wavelength calibration and a correction for the wavelength-dependent detection efficiency of the spectrometer system are crucial to ensure the correct spectrum interpretation and allow for its comparison with those obtained from other systems. However, to achieve an accurate detection efficiency correction, it is necessary to obtain the device-specific spectral response function (SRF). Here, we compare two SRF approximation methods by using either a calibration lamp of known irradiance or calculating the product of efficiency curves provided by the manufacturers of all known optical elements. We discuss the results using radiofluorescence (RF) measurements of two K-feldspar samples as an example. Feldspar infra-red (IR) RF spectra are known to be composed of several overlapping emissions, whose variation with sample mineralogy is still poorly understood and requires more extensive investigations. We find that both methods of sensitivity correction yield broadly similar results. However, the observed differences can alter a spectrum's interpretation. For example, we observe that after peak deconvolution the maximum signal wavelength of the IR-RF peak used for dating applications differs by ~3-13 nm between the two methods, depending on sample and diffraction grating. We recommend using calibration lamps to determine a device's SRF but highlight the need to consider issues such as higher-order signals in the choice of filters to establish the SRF's reliable wavelength range. Additionally, we find that a simple and inexpensive fluorescent white light yields an acceptable wavelength calibration comparable to that obtained from a specialized light source.

Calibration of LiF thermoluminescence dosimeters used to measure the electron energy spectrum

Preliminary research on dose response of LiF thermoluminescence dosimeter to irradiation of 49.3MeV/u carbon ion beam

Uncertainty of LiF thermoluminescence at low dose levels: Experimental results

Studies on Radioluminescence Dose-Rate Measurement Based on LiF:Mg,Ti and SiPM

TL emission spectra from differently doped LiF:Mg detectors

Gamma dose measurement in a water phantom irradiated with the BNCT facility at THOR

Generation of LiF(Mg,Cu,Na,Si) thermoluminescent crystal and evaluation of dose response and sensitivity

The Dosimetric Characteristics of Thermoluminescent Dosimeter

Thermoluminescent characteristics of LiF:Mg,Cu,P and CaSO$_4$:Dy for low dose measurement

EP-1484: the Dosimetric Property of TLD2000 Thermoluminescent Dosimeter

Study on Long-Term Stability of Energy-Storage of TLD 2000C LiF (mg, Cu, P) Thermoluminescence Dosimeter

Radiophotoluminescence response of LiF:Mg,Ti pellets irradiated with clinical proton beams in the 70-200 MeV energy range

Wavelength calibration and spectral sensitivity correction of luminescence measurements for dosimetry applications: method comparison tested on the IR-RF of K-feldspar

TL Response of LiF:Mg,Cu,P (GR200A and GR207A) Exposed to High-Energy 12C Ions

Dosimetry of ultra-high dose rate electron beams using thermoluminescence and optically stimulated luminescence detectors

Saturated Fluorescence Spectroscopy Measurement Apparatus Based On Metastable Li+ Beam With Low Energy

Thermoluminescence measurements of neutron streaming through JET Torus Hall ducts

Comparison of commercial thermoluminescent readers regarding high-dose high-temperature measurements

Scintillation and dosimeter properties of 6LiF/CaF2:Eu eutectic composites

Comparison of Linear Energy Transfer Measurement for Therapeutic Carbon Beam Using CR-39 and TLD

Thermoluminescent dosimeters (TLD-100) for absorbed dose measurements in alpha-emitting radionuclides