Abstract:The graphical abstract is about the preparation of kaolin‐filled EPDM insulating materials and the mechanism of electrical‐thermal‐mechanical between kaolin and EPDM rubber. With the rapid development of offshore wind power, large‐capacity wind turbine generators have put forward higher electrical and mechanical performance requirements for the cable. In this paper, kaolin/ethylene propylene diene monomer (EPDM) composites are prepared to investigate the effect of kaolin content on the electrical properties, mechanical properties and thermal conductivity of EPDM composites. The results show that appropriate amount of kaolin could synergistically improve the electrical‐thermal‐mechanical properties of EPDM. The composite with 30 wt% kaolin content achieves the best performance. The breakdown strength of kaolin/EPDM composites increases by 13.47%–72.19 kV/mm compared with that before modification, and the volume resistivity increases from 1013 to 1015 Ω·cm after modification. In addition, with the doping of kaolin, the tensile strength of composites significantly improves by over 500%–6.97 MPa, and the thermal conductivity of the composite is slightly improved. This work has important guiding significance for the development of insulation materials for cables. Highlights Kaolin in EPDM scattered more uniform after modification. The addition of kaolin improves the electrical‐thermal‐mechanical properties of the composite. Kaolin/EPDM composites have promising applications.

Investigation of mechanical and wear properties of kaolin filled UHMWPE composites

Study on the erosion wear characteristics and mechanisms of UBHMWPE/kaolin composites

Tribological properties of kaolin filled UHMWPE composites in unlubricated sliding

Mechanical and Thermal Properties of Polypropylene (PP) Composites Filled with CaCO3 and Shell Waste Derived Bio-Fillers

Influence of Interfacial Adhesion on Stress-Strain Properties of Highly Filled Polyethylene

Molecular dynamics simulation of α‐ZrP/UHMWPE blend composites containing compatibilizer and its tribological behavior under seawater lubrication

Improved Tribological Properties of Poly(methyl methacrylate) Based Composites by the Synergistic Effect of Incorporating Ultra-High Molecular Weight Polyethylene and Heat Treatment

Study on the Impact of a Combination of Synthetic Wollastonite and 2-Mercaptobenzothiazole-Based Fillers on UHMWPE Polymeric Matrix

Investigation on low-velocity impact and interfacial bonding properties of weft-knitted UHMWPE reinforced composites

Study on char reinforcing of different inorganic fillers for polyethylene composites

Simultaneous Improvements in Wear Resistance and Mechanical Properties of Uhmwpe Nanocomposite Fabricated Via A Facile Approach

Effects of the Mesoporous Filler and Oleophilic Property on the Tribological Behavior of Polyetheretherketone Composites.

Properties of UHMWPE Fibre Reinforced Composites

Collaborative improvement of electrical‐thermal‐mechanical properties of kaolin‐filled ethylene propylene diene monomer and mechanism analysis

Study of stress wave attenuation characteristics of particle ceramic embedded polyurethane composites

Tribological and mechanical behaviors of Fe3O4NPs reinforced UHMWPE biocomposite

Phase morphology and tribological properties of PI/UHMWPE blend composites

Investigating the effect of simultaneous incorporation of Al2O3 and B4C nanofillers in enhancing the wear performance of UHMWPE

UHMWPE/CaSiO3 Nanocomposite: Mechanical and Tribological Properties

Investigation Into Poly(propylene)/Montmorillonite/Calcium Carbonate Nanocomposites

Significant sliding speed effect on the friction and wear behavior of UHMWPE matrix composites