Abstract:Three-dimensional (3D) integration technology using Cu interconnections has emerged as a promising solution to improve the performance of silicon microelectronic devices. However, Cu diffuses into SiO2 and requires a barrier layer such as Ta to ensure acceptable reliability. In this paper, the effects of temperature and strain normal to the interface on the inter-diffusion of Cu and Ta at annealing conditions are investigated using a molecular dynamics (MD) technique with embedded atomic method (EAM) potentials. Under thermal annealing conditions without strain, it is found that a Cu-rich diffusion region approximately 2 nm thick is formed at 1000 K after 10 ns of annealing. Ta is capable of diffusing into the interior of Cu but Cu hardly diffuses into the inner lattice of Ta. At the Cu side near the interface an amorphous structure is formed due to the process of diffusion. The diffusion activation energy of Cu and Ta are found to be 0.9769 and 0.586 eV, respectively. However, when a strain is applied, a large number of crystal defects are generated in the sample. As the strain is increased, extrinsic stacking faults (ESFs) and lots of Shockley partial dislocations appear. The density of the dislocations and the diffusion channels increase, promoting the diffusion of Cu atoms into the inner lattice of Ta. The thickness of the diffusion layer increases to 4 times the value when only a temperature load of 700 K is applied. The MD simulations demonstrated that Ta is very effective as a barrier layer under thermal loading only, and its effectiveness is impaired by tensile strain at the Cu/Ta interface. The simulations also clarified the mechanism that caused the impairment. The methodology and approach described in this paper can be followed further to study the effectiveness of barrier layers under various annealing and strain conditions, and to determine the minimum thickness of barrier layers required for a particular application.

Interface Stability and Solid-State Amorphization in an Immiscible Cu-Ta System

Influence Of Interfacial Texture On Solid-State Amorphization And Associated Asymmetric Growth In Immiscible Cu-Ta Multilayers

Atomistic Modeling of Solid-State Amorphization in an Immiscible Cu-Ta System

Metastable phase formation in an immiscible Cu-Ta system studied by ion-beam mixing, ab initio calculation, and molecular dynamics simulation

Construction of an N-Body Cu–Ta Potential and Study of Interfacial Behavior Between Immiscible Cu and Ta Through Molecular Dynamics Simulation

Interfacial Reaction, Amorphization Transition, and Associated Elastic Instability Studied by Molecular Dynamics Simulations in the Ni-Ta System

Modulation of electronic state in copper-intercalated 1T-TaS 2

Crystalline to Amorphous Transition and Relative Stability of Amorphous Phase Versus Solid Solution in the Cu–Ti System Studied by Molecular Dynamics Simulations

Stability of the metastable phases in the Co-Ta system studied by ab initio and thermodynamic calculations together with ion-beam-mixing experiment

Diffusion behavior of Cu/Ta heterogeneous interface under high temperature and high strain: An atomistic investigation

Atomic assembly of Cu/Ta multilayers: Surface roughness, grain structure, misfit dislocations, and amorphization

Deformation Mechanism of Depositing Amorphous Cu-Ta Alloy Film via Nanoindentation Test

Unusual Alloying Behavior At The Equilibrium Immiscible Cu-Nb Interfaces

Interface-mediated Structural Evolution of Immiscible Co-Cu Multilayers Upon Solid-State Reaction

Interface-Driven Solid-State Alloying in an Immiscible Cu-W System

Formation of an Face-Centered Cubic Ta-Rich Solid Solution by Ion Beam Mixing in the Immiscible Ag-Ta System

Atomistic Mechanism of Interfacial Reaction and Asymmetric Growth Kinetics in an Immisciblecu−rusystem at Equilibrium

Calculation of Phonon Spectra to Predict the High-Pressure Metastable Phase in an Equilibrium Immiscible Cu–Ta System

Solid-state amorphization of Cu nanolayers embedded in a Cu64Zr36 glass

Metastable Crystalline Phases Formed in the Fe–Ta System by Solid-State Reaction

Structural Stability and Amorphization Transition in the Ni–Ti System Studied by Molecular Dynamics Simulation with an N-Body Potential