Abstract:Silicon carbide (SiC) is an effective material for high-temperature engineering applications owing to its desirable properties such as high elastic modulus, high hardness, and melting temperature, high thermal conductivity, good corrosion and oxidation resistance, low density, and coefficient of thermal expansion compared with other advanced ceramics. Nevertheless, poor sinterability and low toughness limit its use, which can be overcome using appropriate additives. In this study, the effect of different amounts of nano-β-SiC (0, 5, 10, and 15 wt.%) and graphene (0, 1, 2, and 3 wt.%) particles on the sinterability behavior and microstructure of SiC composite has been investigated. After weighing, dispersing nano-β-SiC and graphene, and mixing the starting materials, milling was carried out at 180 rpm for 3 h. The materials obtained were then compressed uniaxially under a pressure of 75 MPa and then were compressed again through CIP under 150 MPa. To remove volatile products, the pyrolysis process was performed at 800 °C under Ar atmosphere. Finally, the samples were sintered at 2200 °C for 2 h by the pressureless sintering process. XRD analysis was used to investigate the phases and FESEM images were used to study the microstructure. According to the XRD patterns, β-SiC particles were converted to α-SiC, which was accompanied by the elongation of SiC grains. Also, no reaction was observed between graphene and the SiC matrix. According to the FESEM images, the samples containing 5 wt.% nano-β-SiC and 1 wt.% graphene showed a uniform distribution of reinforcement particles but with increasing the amount of the reinforcement particles, agglomeration was observed. According to the results, upon increasing the nano-β-SiC up to 5 wt% and graphene up to 1 wt.%, all the measured properties including relative density, and linear shrinkage improved and reached 99.04%, and 18.01%, respectively. However, with increasing the additives, these properties deteriorated due to increasing porosity and agglomeration in the composite structure.

Preparation of A MoSi2-SiCp composite by reactive sintering without pressure

The study of pressureless-sintered Mo(Si,Al)(2)-SiC composite

Synthesis of SiC/MoSi2 composite by mechanical alloying and reactive sintering

Microstructural characterization of sintered MoSi2/SiCp composites

MoSi_2/SiC COMPOSITE PREPARED BY USING REACTION - MELTING INFILTRATION SINTERING

Microstructural Characterization of Sintered MoSi<sub>2</sub>/SiC<sub>P</sub> Composites

In-situ Preparation of Nano MoSi 2 SiC Composite by Melt Infiltration of Silicon Method

Preceramic Paper-Derived SiCf/SiCp Composites Obtained by Spark Plasma Sintering: Processing, Microstructure and Mechanical Properties

Microstructures and performances of pressureless sintered MoSi2-Al2O3 composites

Electrical Resistivity and Microstructure of Pressureless Reactive Sintered MoSi2–SiC Composite

Effect of Pressure on the Solidification Behavior and Mechanical Properties of SiCp/Al-Mg Composites

Fabrication and Mechanical Properties of SiCw/MoSi2–SiC Composites by Liquid Si Infiltration of Pyrolyzed Rice Husk Preforms with Mo Additions

Microstructure and thermal properties of SiCp/Cu composites with Mo coating on SiC particles

Fabrication of C/SiC composites by siliconizing carbon fiber reinforced nanoporous carbon matrix preforms and their properties

Fabrication and Mechanical Properties of Si3N4/SiC Nanocompoisites under Pressureless Sintering.

SiC-Based Composite Material Reinforced with Molybdenum Wire

Effect of Sintering Process on Conductivity and Mechanical Properties of In-situ Formed Mo2 C/Cu-based Composite

Pressureless sintering of SiC matrix composites reinforced with nano-β-SiC and graphene

Processing and Mechanical Properties of Multiphase Composites Based on Mo–Si–Al–C System

Microstructure and Hardness Performance of a SiCp/Al Composite by Pressureless Infiltration Technique

Fabrication and Mechanical Properties of SiCw(p)/SiC-Si Composites by Liquid Si Infiltration using Pyrolysed Rice Husks and SiC Powders as Precursors