Abstract:The objective of this work is to analyze the mechanism of interaction between AS4 carbon fiber and a phenolic epoxy matrix in composites cured by electron beam and to improve the interlaminar shear strength (ILSS) of the composites by modifying the carbon fiber. Some promising results have been achieved by electrochemical treatment of the carbon fibers and subsequent coating with an electron-beam-compatible coupling agent. The ILSS of an electron-beam-cured composite was improved from 72.1 to 81.1 MPa. The morphologies of untreated and treated carbon fibers were characterized by the scanning electron microscope (SEM), the atomic force microscope (AFM) and X-ray photoelectron spectroscopy (XPS) respectively. Surface analysis showed that after treatment in electrolytes, the surface of the carbon fibers chemisorbed both oxygen-containing groups and nitrogen-containing groups, and the surface roughness was increased. It is observed that the properties of the carbon fiber surface play an important role in the adhesion between carbon fibers and the matrix resin in electron beam cured composites. The carbon fiber surface properties varied according to the type of electrolyte used in the anodic oxidation. Acidic electrolytes such as sulfate acid are recommended as effective electrolytes for electrochemical treatment to improve interfacial adhesion in the EB curing process, since no improvement in fiber/matrix interfacial adhesion is found in alkaline electrolytes. The EB curable coupling agent can screen the basic groups on the carbon fibers from hindering the cationic polymerization, consequently improve ILSS of EB cured composites.

Study on the Electron Beam Curing Composites Reinforced by AS4 Carbon Fiber

The Curing Behavior and Properties of Diglycidyl Ether of 4,4′-Bis(4-hydroxybenzoyloxy)-3,3′,5,5′-tetramethylbiphenyl and Its Composites with Multi-Wall Carbon Nanotubes

STUDY ON DGE-BHBTMBP/E-51/DDS CURED

The Effect of Carbon-Fiber Surface Properties on the Electron-Beam Curing of Epoxy-Resin Composites

Study on the process of EB curing epoxy matrix composites

Study on the Curing Behavior of Polythiol/phenolic/epoxy Resin and the Mechanical and Thermal Properties of the Composites

Research on Electrical Properties of Carbon Filled Conductive Composites

Investigation of Curing Characteristics of Carbon Fiber/epoxy Composites Cured with Low‐energy Electron Beam

Thermal Characterization of Carbon‐nanofiber‐reinforced Tetraglycidyl‐4,4′‐diaminodiphenylmethane/4,4′‐diaminodiphenylsulfone Epoxy Composites

Diatomite‐filled epoxy resin composites: Curing behavior, dielectric, and thermal properties

Effect of Process Conditions on ILSS of Carbon Fiber / Epoxy Composites Stepwise Curing with Low-energy E-Beam

INFLUENCE OF CARBON FIBER IN EPOXY RESIN CURING

INTERFACE OF ELECTRON BEAM CURED CARBON FIBER REINFORCED COMPOSITES

Electron Beam Curing of Advanced Composites

Investigation on low temperature curing LT-02 epoxy matrix composite

Investigation of irradiation dose rate on curing characteristics of carbon fiber/polymer composites by low-energy electron beam

The Effect of Sizing Agent of Carbon Fibre on the Interface of Electron Beam Cured Composites

Rapid curing epoxy resin and the properties of carbon fiber/epoxy composite

Study on the heating mechanism and macro/micro properties of composite materials under microwave curing

Study on Electron Beam Curing of APTES Functionalized MWNTs/ Epoxy Composites

Thermal Aging Behavior of Carbon Fiber/Epoxy Composites at High Temperature