Abstract:Gelcasting is a new ceramic forming technology for making complex-shaped ceramic products with high performance. The processes used in gelcasting are similar to processes often used in conventional ceramic forming process. However, when new high performance materials are introduced with the aim to improve the strength, defects such as air bubbles or agglomerates that can be found in many traditional ceramic materials are no longer be allowed since this would reduce the performance and reliability of the final ceramic products. The aim of this thesis project was to find an appropriate recipe of the ceramic suspension meanwhile improving the process of gelcasting and obtaining ceramic products with excellent mechanical behavior. To achieve this specified target, alumina and zirconia powders were studied in the following experiments which included rheological measurement of viscosity and storage modulus measurement for ceramic suspensions and drying shrinkage measurement of cast materials. The binder was burned out and the density was measured for ceramic materials sintered at different temperatures. The mechanical strength of sintered materials with high density was evaluated and the microstructure of fracture surfaces of ceramic samples was studied. Through rheological measurement, a good balance between fluidity and solid content of ceramic suspension was found. For alumina suspensions a solid content of 55vol% was selected and for zirconia solid contents of 46, 48 and 50vol% were studied. A monomer was dissolved in the suspension and an initiator was added to facilitate the polymerization of the monomer when the temperature was increased to around 70oC. The failure analysis of the fractured bending bars showed that the defects that caused the failure were not air bubbles but agglomerates. As a result, in future research for ceramic gelcasting with the intention to improve the mechanical strength, the suggestion is to use an appropriate recipe for the ceramic suspension and focus on elimination of granules and agglomerates from the suspension

Gelcasting of BaTiO3 ceramic powders

GELCASTING OF BaTiO_3-BASED PTC CERAMICS

Ba0.6Sr0.4TiO3-MgO ceramics from ceramic powders prepared by improved aqueous gelcasting-assisted solid-state method

Ba 0.6 Sr 0.4 TiO 3- MgO ceramic powders with uniform microstructures prepared by aqueous gelcasting-assisted solid-state method

Gel Casting of High Strength Ceramics

Gelcasting of PZT

Study on the Process of Si3N4 Ceramic with High Properties by Gel-casting

PREPARATION OF MULLITE-ALUMINIUM TITANATE CERAMIC COMPOSITES VIA GELCASTING

Porous Si3N4 Ceramics Prepared by TBA-based Gel-casting

Effects of Pore-Forming Agent Content on the Properties of Porous 8ysz Ceramics by Tba Based Gel-Casting

Gelcasting of Alumina with a Mixed PVP–MAM System

Gelcasting of alumina ceramics in the mixed acrylamide and polyacrylamide systems

Aqueous Gelcasting of ZrB2–SiC Ultra High Temperature Ceramics

Water based gelcasting of lead zirconate titanate

Suppression of Surface-Exfoliation by Gelcasting Ceramics with Mixed Polymer-Monomer Solutions

Microstructures and dielectric properties of Ba0.6Sr0.4TiO3–MgO ceramics prepared by non-aqueous gelcasting and dry pressing

PREPARATION OF NANO-SiO2-COATED Al2O3 CONCENTRATED SUSPENSION AND ITS GEL CASTING

A Study of Rheological Behaviors of Al2O3-TiO2 Slurry

Study on Thermoplastic Binder and Mixing Technology for Alumina Ceramic Injection Molding

Optimization of the Tape Casting Process for Development of High Performance Alumina Ceramics

Study On Gel-Tape Casting In The Mixed Polyvinyl Alcohol And Acrylamide Systems