Abstract:Thermal fatigue is a potentially significant degradation mechanism in Nuclear Power Plants (NPP). For the fatigue analysis, the thermal load information about components must be determined firstly. In this paper, an experimental study was carried out to obtain local fluid temperatures and local heat transfer coefficients for the safety injection nozzle component in reactor coolant system (RCS). In this mixing tee component a hot jet issues into a cold cross-flow stream from an oblique pipe and the turbulent mixing of two fluids induces local cycling stresses on the adjacent piping wall. Experiments were performed using a special-made heat fluxmeter, which can measure the mixed fluid temperature close to the wall and the heat transfer coefficient between the fluid and the wall. Plexiglass and metallic 1/9-scale mockups were manufactured for flow visualization and heat transfer tests, respectively. All tests were conducted at range of 0–40 for the jet-to-cross-flow velocity ratio. The flow visualization test has obtained general pattern of the flow and identified sensitive zones in the component where the jet and cross-flow interact intensively to cause thermal fatigue more possibly. In the heat transfer test, heat fluxmeters were positioned in the wall at these sensitive zones. The measurement results of temperatures and heat transfer coefficients have been discussed in detail in the paper. These experimental results allow us improving the state of knowledge of the thermal load to be used in the industrial mixing tees in operating for long lifetime assessment and for the design in the basic Nuclear Power Plants.

Selection of the Velocity Ratio in Pressurized Water Reactor T-junction Components Subject to Thermal Shock

Numerical and Experimental Investigation of Flow and Heat Transfer in a T-Junction with Thermal Sleeve

Experimental Study on Heat Transfer Characteristic of T-Junction in Cooling System of PWR

Numerical Simulation of Non-isothermal Jetinto Crossflow for T-junction Pipe with Thick Wall

Transient Mixing Characteristic of Reactor Pressure Vessel under Pressurized Thermal Shock

Influence Evaluation of Loading Conditions During Pressurized Thermal Shock Transients Based on Thermal-Hydraulics and Structural Analyses

Digital Particle Imaging Velocimetre Experimental Study of the Jet-to-Crossflow in a T-Junction with a Sleeve Tube

Thermal-stress modeling of AP1000 reactor pressure vessel due to transient pressurized thermal shock

Large Thermal Gradients on Structural Integrity of a Reactor Pressure Vessel Subjected to Pressurized Thermal Shocks

Experiment Research on Thermal Mixing in Horizontal T-Junction: In-Pipe Temperature and Flow Characteristic Research

Experimental Observations of Thermal Mixing Characteristics in T-Junction Piping

Integrity Assessment Considering Unified Constraint for Reactor Pressure Vessel under Pressurized Thermal Shock

Study on Targeted Influence of Annular Porous Media and Rotating Impeller on Thermal Mixing in T-Junctions

Experimental Investigation on Effect of Distribution Basket to Fluid Flow and Heat Transfer in the Head of Pressurizer

Optimization of 54-Element Pressure Tube SCWR Bundle Through Neutronics/thermalhydraulics Coupling Analysis

Numerical Investigation on the Thermal Stratification in a Pressurizer Surge Line

Effect of Coolant Water Temperature of ECCS on Failure Probability of RPV

Experimental Investigation on Heat Transfer Characteristics in a Safety Injection Nozzle Component in PWR

Numerical Simulation of Transient 3-D Turbulent Heated Jet into Crossflow in a Thick-Wall T-junction Pipe

Effect of Coolant Water Temperature of Emergency Core Cooling System on Failure Probability of Reactor Pressure Vessel

Experimental Investigation on Heat Transfer of Supercritical Pressure Water Flowing in Sub-Channel with Triangle Distribution in Reactors